HUANUO HNCM6 User manual

UNPACKING INSTRUCTIONS
!Carefully open the carton, remove contents and lay out on cardboard or other
protective surface to avoid damage.
!Check package contents against the Supplied Parts List in the next page to assure
that all components were received undamaged. Do not use damaged or defective
parts.
!Carefully read all instructions before attempting installation.
IMPORTANT SAFETY INFORMATION
!Install and operate this device with care. Please read this instruction before
installation, and carefully follow all instructions contained herein. Use proper safety
equipment during installation.
!Please call a qualified installation contractor for help if you don't understand these
directions or have any doubts about the safety of the installation.
Do not use this product for any purpose or in any configuration not explicitly specified
in this instruction. We hereby disclaims any and all liability for injury or damage
arising from incorrect assembly, incorrect mounting, or incorrect use of this product.
Triple Monitor Stand V1.0
HNCM6

1

Option A：
Install the Weighted Base
Option B：
Install the Grommet Base
1.Install the Pole(a) to the Weighted Base(b)
with 3 pcs of M5x14 Bolts(g). Use the Allen
Key(o) to tighten the bolts. See Figure 1.
2.Optionally, you can drill a 3/8”(10mm)
diameter hole in your desk and secure it by
using the Support Plate(j), M10 Washer(k),
Spring Washer(l) and M10 Bolts(i). Fasten the
M10 Bolt with the provided Wrench(p). See
Figure 2.
1.Install the Grommet Base Plate(m) to the
Pole(a) with 3 pcs of M5x14 Bolts(g). Tighten
the bolts with the Allen Key(o). See Figure 3.
2.Position the Pole(a) on the mounting
surface. Install the Spring Washer(l) and M10
Washer(k) to M10 Bolt(i). Insert the bolt(i) into
the Support Plate(j) and the desk hole. Fasten
the M10 Bolt(i) with the provided Wrench(p).
See Figure 4.

Option B：
Install the Grommet Base
2.Install the Grommet Base Plate(m) to the
Pole(a) with 3 pcs of M5x14 Bolts(g). Tighten
the bolts with the Allen Key(o). See Figure 5.
3.Position the Pole(a) on the mounting
surface. Install the Spring Washer(l) and M10
Washer(k) to M10 Bolt(i). Insert the bolt(i) into
the Support Plate(j) and the desk hole. Fasten
the M10 bolt(i) with the provided Wrench(p).
See Figure 6.

Thank you for choosing our product! We strive to provide the best quality
and services for our customers. Would you kindly share your experience on
Amazon if you are satisfied? Should you have any issues, please don't
hesitate to contact us.
Telephone：[phone] Mon-Fri 10am - 6pm (PST) (USA)
Email：[email protected] (US/CA/DE/UK/FR/IT/ES/JP/AU)