HUBBELL LIGHTING Compass CELEM User manual

© 2020 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd • Greenville, SC 29607 / Tel [phone] / Website www.columbialighting.com
Page 1/2 Rev. 06/08/20
COM-CELEM-INST
CELEM
RECESSED EMERGENCY LIGHT
Installation Instructions
IMPORTANT SAFEGUARDS
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
1. Review the diagrams thoroughly before beginning.
2. All electrical connections must be in accordance with local codes, ordinances, and the National Electric code.
3. Disconnect power at fuse or circuit breaker before installing or servicing.
4. Do not use outdoors.
5. Do not mount in hazardous locations, or near gas or electric heaters.
6. Do not let power cords touch hot surface.
7. Equipment should be mounted in locations and at heights where it will not be subjected to tampering by
unauthorized personnel.
8. The use of accessory equipment not recommended by the manufacturer may cause an unsafe condition.
9. Do not use this equipment for other than intended use.
10. All servicing should be performed by qualified personnel only.
11. Allow battery to charge for 24 hours before first use.
Orange 277VAC
Black 120VAC
White Neutral
2nd Battery
1st Battery
WIRING DIAGRAM (SEE FIG 1)
Use Flexible Conduit Only

© 2020 Columbia Lighting, a division of Hubbell Lighting, Inc. Specifications subject to change without notice.
701 Millennium Blvd • Greenville, SC 29607 / Tel [phone] / Website www.columbialighting.com
Installation Instructions
COM-CELCEM-INST
CELEM Surface
RECESSED EMERGENCY LIGHT
RECESSED CEILING OR WALL MOUNT
NOTICE: MUST WEAR GLOVES.
1. Position recessed kits between joists. Make sure bar hangers are hung
in the correct position. Position recessed kits temporarily by hammering
“nail-in” tabs on bar hangers, then secure permanently with nails. Bar
hangers should be level with bottom of joists. Adjust height of recessed kits
vertically using adjusting slots and then tightening all screws on adjusting
slots and bar hanger bracket to secure adjusting bracket and bar hangers.
(see Fig 4)
2. Separate trim plate, press two side spring to take out the module, connect
battery connectors.
3. Hang safe rope to the module clip.(see Fig 5)
4. Make proper electrical connections. If using 120VAC, connect black and
white leads to the building utility. If using 277VAC, connect orange and
white leads to the building utility. Cap o unused wire. (see Fig 5)
5. Assemble trim plate back use M3*15 screws. (see Fig 6)
6. Adjust position of lamp heads as needed.
NOTICE: MUST WEAR GLOVES.
Bar Hangars Recessed Kits
Tighten Screws
after positioning
Joists
Ground
Safety Cable
Screws
(M3*15)
Page 2/2 Rev. 06/08/20