Hubbell LightOWL LODT Manual

9601 Dessau Road, Building One | Austin, TX 78754 Toll Free: 888-698-3242 | Fax: [phone] | www.hubbell-automation.com 1501B 03.02.2016
LightOWL® Dual Technology Passive Infrared and Accoustic
Sensors LODT and LOIR
Installation and Setup Procedure
Locking screw
loosen tighten
PULL
Cover Body Bracket Cover Mounting
Bracket
Wiring
Harness
ACAK
Acoustic Ceiling
Adaptor Kit
(optional)
INSTALLATION
INSTALLATION OPTIONS
1. Insert wiring through bracket legs. Secure bracket to wall or ceiling. For ACAK Installation see page 2.
“POP”
2. Connect building wiring harness with wire nuts. Snap
bracket cover in place to conceal wiring and bracket. Feed
wiring harness through the back of the sensor body and out
exit slot.
3. Snap sensor into mounting post. Plug wiring harness into
connector located on the left side opposite exit slot and
place wiring under wire tabs. Align sensor and tighten
position locking screw.
4. Replace sensor cover.

Page 2 72-00122 Rev C
ACAK INSTALLATION (optional)
PHYSICAL WIRING
TROUBLE SHOOTING
SENSOR PLACEMENT
CONTROLS
Wrong
Correct Hallway
Insert ACAK into mounting bracket and twist clockwise 90ºto lock
into place. Screw bracket and self-cutting AKAC into ceiling tile
and secure with washer and nut.
When placing the sensor in a
room, do not place where the
sensor is aimed out through a
door. The sensor can detect
hallway trac, forcing lights-on.
HID Lights Flash
Bright-Dim-Bright
Control “Floating” Unplug all RJ-12 from
Flashing Lamp
Replace Aected
Cable
Lights Stay Dim Low Voltage
Shorten to + 10V
Unplug all RJ-12 form
Flashing Lamp
Replace Aected
Cable
Lights Won’t Dim 15.4 minute
Warm Up
Wait 16 minutes Normal Operation
Lights Won’t Dim Common Shorted
to Control
Remove all but One
sensor from Control
Test One sensor
at a time
Problem Possible Cause Test Result