Hubbell GAI-TRONICS XCP0020A User manual

Pub. 43003-013B
GAI-Tronics Corporation P.O. Box 1060, Reading, PA 19607-1060 USA
610-777-1374 n800-492-1212 nFax: 610-775-6540
VISIT WWW.GAI-TRONICS.COM FOR PRODUCT LITERATURE AND MANUALS
GAI-TRONICS® CORPORATION
A HUBBELL COMPANY
XCP0020A 16-Frequency Control Kit
Field Installation Kit Instructions
Confidentiality Notice
This manual is provided solely as an operational, installation, and maintenance guide and contains
sensitive business and technical information that is confidential and proprietary to GAI-Tronics.
GAI-Tronics retains all intellectual property and other rights in or to the information contained herein,
and such information may only be used in connection with the operation of your GAI-Tronics product or
system. This manual may not be disclosed in any form, in whole or in part, directly or indirectly, to any
third party.
General Information
The Model XCP0020A 16-Frequency Control Kit includes the following components:
Qty Description
1SEL Button
1HOME Button
1UP Button
1DOWN Button
Installation
NOTE To enable the 16-frequency option, you must first contact GAI-Tronics at (800) 492-
1212. Select the prompt to speak to a radio products service technician. Have your order number
available to verify your purchase. Also, be in front of the console to receive and enter the activation
codes.
1. Remove the existing blank buttons from the F1 through F4 button locations on the front panel and
replace with the buttons included in this kit. Refer to Figure 1 for the location of the buttons to be
replaced.
2. To remove a button, use needle-nose pliers to grasp the top and bottom as close to the base of the
button as possible without scratching the console. Squeeze in at the top and bottom points and gently
pull the button out.

Pub. 43003-013B
XCP0020A 16-Frequency Control Kit Page: 2of 2
4/02
3. To install a button, use needle-nose pliers to squeeze in at the top and bottom of the button. Slide the
button into the appropriate place on the key panel until it snaps into place.
4. Please refer to your ICP9000 Series Desktop Console Operator’s Manual, 43004-016, for further
information. The GAI-Tronics CARD Suite Software (XAC1000A) contains the necessary
information for configuration of this option in your ICP9000 Series Desktop Console. You must
“read console” after activation to be able to enter more than the standard 4 frequencies per channel.
Figure 1.