HULALA HOME SBHM0785 User manual

HULALA
H O M E
01/27
NOTE:
This brochure contains IMPORTANT safty info. Please read and keep for future
reference.
ITEM NO.SBHM0785

MAINTAINANCE AND WARNING
1.Keep furniture away from heat sources.
2.Do not clean furniture with harsh cleaner or polishes.Do not use
detergents,solvents,abrasives,spray packs or leather cleaner.
Use non-color mild soa with warm water to clean spills(Mix 1:10
soap to water).
3.Do not place furniture under direct sunlight,material will possibly
fade over time.
4.Do not use on site dry cleaning machine.Children should not climb
or jump on the furniture.
5.Do not write on furniture that is not protectedby a padded barrier.
6.Not for commercial use,only for residential use.
Weight Limitation
100 LBS
02/27

EXPLOSIVE VIEW
2PERSONEN
03/27
OVERVIEW
A
B
C
D
E
F
F
G
H
I
J
K
L
L
L
L
M
N
N

PARTS LIST
A B CDx1
E F GHx1
I J K
x1
x1
x1
x1
x2
x1
x1
x1
x1
04/27
L x4
Mx1 Nx2

HARDWARE LIST
HARDWARE SPARE LIST
#1 x52 #2 x26
#1 #2x1 x1
05/27
∅3*15mm*7#
∅3.5*14mm*7#

#5 x8 #6 #7 #8
#9 #10
TOOL LIST
#11 #12 #13
#16 #17x1 x1
x8 x4 x4
x4 x8 x4 x4 x4
HARDWARE LIST
06/27
#4 x8
#14 x2
#3 x16
∅1/4*1-3/4"∅3.5*19mm*7#
∅3*35mm*7#
#15 x12
∅8*30mm

ASSEMBLY INSTRUCTIONS
STEP-1
07/27
B
Forward
Back
#17 x1#15 x12
∅8*30mm
#15x12
#17
N
N
N
B
Use screw#15 to attach clump weight(N) to the reverse side of
bottom panel(B)，the position is behind the bottom panel(B) as
picture show,tighten screw#15 with screwdriver#17.
Attention:
The word "back"in the picture
refers to the direction of bottom
panel(B) with backpanel slot.

ASSEMBLY INSTRUCTIONS
STEP-2
#4 x8 #5 x8 #6 x8
08/27
B
L
L
L
L
#4x8
#5 x8
#6 x8
#16
L
#16 x1
∅1/4*1-3/4"
Use bolt #4，spring washer #6 and plat washer #5 to attach leg (L) to
part (B),make sure all holes aligned ，tighten bolt #4 with allen key
#16.

ASSEMBLY INSTRUCTIONS
STEP-3
09/27
B
M
M
B
Screw leg (M) into the corresponding hole of part (B) with hand as
picture show.

ASSEMBLY INSTRUCTIONS
STEP-4
#16 x1
10/27
#16
B
E
D
D
B
D
B
#16
E
B
B
E
Insert panel (D)&(E) into the corresponding hole of part (B) ,make
sure all holes aligned and tighten it with allen key #16.