Human Touch pc 085 User manual

SERVICE LEVEL:
2
Tools required:
4 mm (5/32
"
)
Allen Key, flat-head screwdriver, nail clipper or other instrument suitable for cutting zip ties
SAVE ALL REMOVED PARTS FOR USE DURING REASSEMBLY
1
PC-085IS-AR-A0
REPLACING AN ARMREST
PC-085
1. Using a flat-he
ad screwdriver, pop out the inside side panel (it is connected to the chair using three plugs)
(Fig.1)
.
2. If you are replacing the left-hand armrest, locate the cables connected inside the armrest, then disconnect them
(Fig.2)
.
NOTE:
If there is a zip tie in the way, cut and remove it.
3.
Using a
4 mm (5/32
"
)
Allen Key
, remove the two screws that hold the armrest in place (and their washers)
, then remove the armrest
from the chair
(Fig.2)
.
(Fig.1)
(Fig.2)
Side
panel
3 plugs
REMOVING THE ARMREST
Cable

1.
Place the armrest into position and, if you are installing a left-hand armrest, connect the armrest cable to the electric recline cable.
2. Insert and hand-tighten the screws/washers that hold the armrest in place.
NOTE:
The smaller washer installs on each screw
before the larger washer.
CAUTION:
Be careful not to drop the screws into the chair arm, as you will need to turn the chair upside-down to
retrieve the screws from inside the armrest.
3. Tighten all screws using a
4 mm (5/32
"
)
Allen Key.
INSTALLING THE NEW ARMREST
2
Please send any questions or comments regarding these instructions to:
[email protected]
©
2007
H
uman Touch
™
,
LLC.