Humanware APH MATT Connect User manual

2

3
Getting Started
1. On a flat and stable surface, hold your
stand upright, making sure the panel with
the word “MATT Connect” is facing
towards the back. Hold the handle with
one hand and unfold the lower panel with
your other hand until it is flat on the table.

4
2. Unfold the top panel until it is roughly
parallel with the lower panel.
3. Hold your tablet with the screen side
facing you, making sure the HumanWare
logo is at the top. Carefully insert the top
of your tablet into the slot and slide it
forward until you reach the back end of
the slot. Push the bottom part of the

5
tablet down; you will hear a click
indicating that your tablet is fastened.
4. Connect the power supply cable to the
recharge port and plug it to an outlet. The
recharge port is located on the right side
of the tablet. Allow the tablet to recharge
until the battery is full.
IMPORTANT: Use caution while inserting
the cable into the recharge port.
5. Press and hold the power button, located
on the bottom edge of the tablet, to
power on your tablet. The APH and
Android logos will appear on screen.
Your tablet will take about 30 seconds to
initialize.

6
6. You will now be guided through several
setup wizards. IMPORTANT NOTE
BEFORE STARTING, visual accessibility
settings are available for use before
completing the wizards. Please be sure to
tap “Vision settings” at the bottom of the
screen and make any required adjustments
prior to entering the wizard.
For more information on how to use the
Prodigi software, please refer to the User
Guide.

7

8
Customer Support
For customer support, please contact the
HumanWare office nearest you or view our website
at: www.humanware.com
North America: 1 (800) 722-
3393 [e-mail]
Europe: [phone] 800
[e-mail]
Australia / Asia: [phone]
[e-mail]
ACCD-0312
Rev 04