Humanware MATT Connect User manual

2

3
Getting Started
1. On a flat, stable surface, hold your stand
upright, ensuring the panel with the word
“MATT Connect” faces toward the back.
Hold the handle with one hand and unfold
the lower panel with the other hand until it
is flat on the table.

4
2. Unfold and lift the top panel until it is
roughly parallel with the lower panel.
3. tHold your tablet with the screen facing
you, ensuring the HumanWare logo is at
the top. Carefully insert the top of your
tablet into the slot and slide it forward
until you reach the back end of the slot.
Push the bottom part of the tablet down;

5
you will hear a click indicating that your
tablet is locked into position.
4. Connect the power supply cable to the
charging port and plug it into an outlet.
The charging port is located on the right
side of the tablet. Charge the battery to
full capacity.
IMPORTANT:
•Only use power adapter and cable
supplied with MATT-Connect.
•Use caution while inserting the cable
into the charging port.

6
5. Press and hold the power button, located
on the bottom edge of the tablet, to
power on your tablet. The APH and
Android logos will appear on screen.
Your tablet will take approximately 45
seconds to initialize.
6. You will be prompted through several setup
wizards.
IMPORTANT: Visual accessibility settings are
available before completing the wizards. Be sure
to tap “Vision Settings” at the bottom of the screen
and make any required adjustments prior to
entering the wizard.
For more information on how to use Prodigi
software, please refer to the User Guide.

7

8
Customer Support
For customer support, please contact the
HumanWare office nearest you or view our website
at: www.humanware.com
North America: 1 (800) 722-
3393 [email protected]
Europe: [phone] 800
[email protected]
Australia / Asia: [phone]
[e-mail]
ACCD-0312
Rev 03