Humanware Prodigi Connect 12 User manual

Page 1
GETTING STARTED
1. On a flat and stable surface, hold your
Prodigi stand in an upright position making
sure the panel with the word “PULL” is
facing you. While holding the handle with
one hand, unfold the “PULL” panel with
your other hand until it is flat on the table.
2. Next, unfold the top panel until it is roughly
parallel with the lower panel.

Page 2
3. Hold your tablet with the screen side facing
you, making sure the Samsung logo is
upside down. Carefully insert your tablet
into the slot and slide it forward until you
reach the back end of the slot. Lock the
front bracket to fasten your tablet onto the
folding stand.

Page 3
4. Connect the USB Recharge Cable to the
Power Supply.
5. Carefully connect the cable to the
recharge port and plug it to an outlet. The
recharge port is located on the left side of
the tablet.
IMPORTANT: Use caution while inserting
the cable into the Recharge Port.
IMPORTANT: Do not close your folding
stand with your tablet in it when the
recharge cable is plugged in. You could
damage the recharge cable or tablet.

Page 4
6. Allow the tablet to charge until the battery is
full (initial charge is 8 hours).
7. Press and hold the Power button to power
on your tablet. Your tablet will take about
30 seconds to initialize. The Samsung logo
will appear on the screen (possibly upside
down for booting, as the tablet is inserted
upside down).
8. Tap the Zoom In-Out buttons to adjust the
zoom level. To increase character size,
tap the Zoom In button (the right one). To
decrease character size, tap the Zoom Out
button (the left one). You can also tap and
hold the Zoom In-Out buttons to
progressively adjust the zoom level, and
release once you reach your desired zoom
level.
For more information on how to use Prodigi,
please refer to the user guide.
[End of document: VER 02-2015-12-14]

ACCD-0132
REV 02