Hunter Hunter Accessory Table 20523 User manual

Hunter Accessory Table
Installation Instructions
47007-01 11/20/2007
Shown with fan and light kit (not included)

Read all instructions carefully before beginning installation. Save these instructions.
CAUTIONS
• Readentireinstallationinstructionscarefullybeforebeginninginstallationandsavetheseinstructions.
• DONOTclimbonpoleortable.
• Followtheassemblyandoperationinstructionsincludedwiththefan.
• UseONLYHunterreplacementparts.
• DONOTassembleorplacethisfanonunlevelground.
• InstallthisaccessorytableONLYonHunterTMfanmodels20523and28492.
WARNINGS
• Toreducetheriskofthefanassemblytiltingorfalling,neverplaceobjectsonthetablewithacom-
binedweightofmorethan20lbs.
Troubleshooting
Tablewobbles.
1. Remove all objects from the table. Carefully lift the fan to ensure all three
feet are properly installed.
2. Check that the notches in the table are sitting properly on the pin.
3. Tighten all screws.
For other problems or ques-
tions, contact the Hunter Fan
Company Technical Support
at
1-888-830-1326
or
http://www.hunterfan.com

Your new accessory Hunter table can be installed at one of three heights:
*shown with optional accessory light kit (not included)
bar height standard table height lounge height
 Note:Be sure to hold the power cord out of the
way of the bolt. Do not allow the power cord to
slip down the pole.
1. Insert the bolt into the lower pole section and
secure with the cotter pin. Cotter
Pin
Bolt
44.5”
(113cm) 31.5”
(80cm) 23”
(58cm)
Step1

3. Being careful not to damage the pole finish,
(with assistance from at least one other person)
place the hole in the center of the table over the
lower pole segment. Align the notch in the lower
adapter with the bolt. Rest the table on the bolt.
4. With the notch resting on the bolt, rotate the
table clockwise to secure it to the pole.
2. Attach the upper adapter to the table with
six adapter screws with washers. read the
lower adapter into the upper adapter and
rotate one to two turns.
Note: e lower adapter should not be
over-tightened. It should remain loose in
the upper adapter to properly attach to the
table.
Table
Lower Pole
Segment
Table Upper
Adapter
Lower
Adapter
Hardware Needed:
Adapter Screw
64193-03-247
(x 6)
Table
Hardware Needed:
Washer
64187-01-247
(x 6)
Step2
Step3-4

HunterFanCompany
2500FriscoAvenue
Memphis,Tennessee38114
© 2007 Hunter Fan Company