i5 Industries KAI CT120 User manual

Assembly: Conference Table
MODELS: CT120 120” Conference Table
CT144 144” Conference Table
Scan Me
to watch
Assembly
Instructions

Place all laminated parts on a clean and smooth surface such as •
a rug or carpet to avoid the parts from being scratched.
Check to be sure that you have all parts and hardware. •
Remove all wrapping materials, including staples & packing •
straps before you start to assemble.
Line up holes for cam locks. •
Put on sticker caps last. •
Keep all hardware parts out of reach of children. •
Inspect all holes to ensure their isn't any debris. •
TWO PEOPLE ARE
REQUIRED TO
ASSEMBLE AND MOVE
THIS MODEL
Required tools:
Recommended tools:
INFORMATION
Flathead or Philips
#2 Screwdriver
#2
Highly recommended when
assembling: L-shape
configuration or
attaching pedestals
120”/144” CONFERENCE TABLE

PART QTY.
MODESTY PANEL 2
END PANEL 3
TOP 2
PART QTY.
Metal Pin
21
21
21
21
21
Cam Lock
Set Screw
Cap Sticker
Adjustable Glide 6
Wood Dowel
PARTS & HARDWARE
B
C
D
E
F
2
Connecting Plate
G
A
120”/144” CONFERENCE TABLE
2
Draw Bolt
I
24
Screw
K

1. HARDWARE INSTALLATION
Assemble modesty panel with end panels. Place all hardware in its position.
Take both end panels and push them into the modesty panel. Use the cam lock
to lock the metal pin in place.
(F)
2X (A)2X (F)
(E)
(A)
Insert by
hand only
7x (B)
120”/144” CONFERENCE TABLE

2. HARDWARE INSTALLATION
Flip base and place one side of the top of the base lining up the holes. Repeat for the
other side of the top. Once both sides are on use (C) to secure the cams. Then use the
draw bolts (I) to pull the 2 sides together to take away any gap in the center.
10X (A)10X (F)
(A)(F)
Insert by hand only
10x (C) 10x (B)
(I)
120”/144” CONFERENCE TABLE

(D)
3. PUT ON CAP STICKERS
Note: Place cap stickers on any exposed holes.
21X (D)
TWO PEOPLE ARE
REQUIRED TO
FLIP AND MOVE
THIS MODEL
120”/144” CONFERENCE TABLE