IBM 6361 User manual

G544-2002-0
IBM 6361 Mag Card Unit
Customer Setup Guide
--...- -
----
------
- ----
- -. ---
------
-----
----_.-

First Edition (July 1981)
Warning: This equipment generates, uses, and can radiate radio
frequency energy and if not installed and used in accordance
with the instruction manual, may cause interference to radio
communications. It has been tested and found to comply with
the limits for a Class A computing device pursuant to Subpart
J of Part 15 of FCC Rules, which are designed to provide
reasonable protection against such interference when operated
in a
commercial environment. Operation of this equipment in a
residential area is Iikely to cause interference in which case the
user at his own expense will be required to take whatever
measures
may be required to correct the interference.
Changes are
periodically made to the information herein; these changes will be incorporated in
new editions of this publication.
Use this publication only for the purposes stated in the Preface.
Publications are not stocked at the address below. Requests for copies of IBM publications
and for technical information about the system should be made to your IBM representative or
to the branch office serving your locality.
This publication could contain technical inaccuracies or typographical errors. Use the Reader's
Comment Form at the back of this publication to make comment about this publication.
If the form has been removed, address your comments to IBM Corporation, Information
Development, Department 95H, Building 998, 11400 Burnet Road, Austin, Texas, 78758.
IBM may use and distribute any of the information you supply in any way it believes appropriate
without incurring any obligation whatever. You may, of course, continue to use the informa-
tion you supply.
©Copyright International Business Machines Corporation 1981

Preface
Purpose
Audience
Contents
Prerequisite Reading
Related Publication
This publication provides step-by-step instructions for setting up the IBM 6361 Mag Card
Unit and cable-connecting it to the IBM Displaywriter System.
Th
is publication is intended for IBM D is pi aywriter System customer personnel who are
responsible for setting up the system in the work area.
This guide has
two sections:
• Section 1, "Operator Information," contains information the operator needs if
setup problems are encountered.
• Section 2, "Setting up the IBM 6361 Mag Card Unit," contains instructions for
placing and cabling the Mag Card Unit to the work station.
The Customer Planning Guide for the IBM DisplaywriterSystem, G544-0852. This
publication provides the information needed to successfully prepare for the arrival and
setup of the system. The guide discusses such topics as system component sizes and
weights, furniture dimensions, supplies, and physical, electrical, and environmental
requirements of the system.
The IBM DisplaywriterSystem Customer Setup Guide, G544-0858. This guide gives
detailed step-by-step instructions for system setup. With this guide, customer personnel
can unpack system components, arrange them in the work area, connect power cords and
intermachine cables, prepare the units for operation, and run the system verification tests.
This guide is shipped with the system.
Preface

Contents
Section 1. Operator Information ................................ 1
Section 2. Setting
Up The IBM 6361 Mag Card Unit ................• 3
Contents iii

Section 1. Operator Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .. 1
Section 1. Operator Information 1-1

SECTION 1. OPERATOR INFORMATION
Shipping Damage
Missing Items
Setup Problems
Access Code
Telephone Numbers
1-2
If your Mag Card Unit has physical shipping damage that willprevent setup, stop setup
and call your local IBM branch office for service.
If the shipping damage is minor, and will not prevent setup, complete setup and then call
your local I BM branch office for service.
If your Mag Card Unit arrives with any items missing, such as magnetic cards used for
setup, call your IBM marketing representative.
If you have any setup problems you cannot correct, call the IBM Office Systems Support
Center (OSSC) for Assistance. You must have the system's access code when you call
for assistance.
The last seven digits
of the IBM 6580 serial number are the access code. This code is
required whenever you call the IBM Office Systems Support Center (OSSC) for
assistance.
Use
one of the following toll free telephone numbers to call for assistance:
U.S. Outside of Texas
(Including Puerto Rico)
Alaska, Hawaii and Guam
Within Texas
Within Dallas
800-527-9293
0-214-748-1560
(Call Collect)
1-800-492-9774
748-1560

Section 2. Setting Up the IBM 6361 Mag Card Unit ................. .
Section 2. Mag Card Unit Setup 2-1

SECTION 2. SETTING UP THE IBM 6361 MAG CARD UNIT
STEP 1. Place the Mag Card Unit in its permanent location in the work
area.
2-2
Route the cable (number 1) to the work station electronics
module .
IBM 6580
Display
Station
IBM Displaywriter System
Work
Station
Note: The Mag Card Unit can be placed at the right or the left of the
work station for operator convenience.

STEP 2. Make sure the work station power switch is OFF, then connect
the
Mag Card Unit cable 1 to socket 1 on the work station
electron ics module.
MAG
CARD
UNIT
(I~
o H
I 0 [
00
Of
Of
0(,
I 0 H
l@ _
When connecting the cable plug, tighten the holding screws
finger tight only.
Socket
Holding Screws
ELECTRONICS
MODULE
Turn
Section 2. Mag Card Unit Setup 2-3

STEP 3. Connect the Mag Card Unit power cord
to the wall socket.
MAG
CARD
UNIT
STEP 4. Turn ON the Mag Card Unit Power switch.
2-4
ELECTRONICS
MODULE

STEP 5. Locate the two magnetic cards that were sh ipped
with the machine.
Insert ONE of the magnetic cards in the Pack Feed Slot, as
shown. (Note
the position and direction of the arrow on the
card)
STEP 6. Make sure the Mag Card Unit has good stability (does not
wobble) when it is in its final location.
If necessary, rotate the adjustable base pad (right front corner)
to provide stability.
STACKER
Section 2. Mag Card Unit Setup 2-5

2-6
YOU HAVE COMPLETED SETUP OF THE MAG CARD UNIT.
INSTRUCTIONS FOR TESTING THE MAG CARD UNIT WITH THE IBM
DISPLAYWRITER SYSTEM ARE IN THE SYSTEM SETUP GUIDE.

...;
E
c::
Q)
0
E
.....
0..
,~
::J
..c::
0'
....
l.l
co
0>
Q)
c::
In
'';:; 0
0
....
In
~
~
~
....
E
"0
Q)
"0
E
Q)
....
E
~
E
::J
0>
0
'-
....
::J
Q)
..c::
~
....
..c::
0
,~
'-
~
0
In
Q)
E > '';:;
Q)
'Vi
:0
c::
0
Q)
0.
In
Q)
~
In
::J
:::J
In
In
~
Q)
(.)
'-
c::
c.
~
Q)
(.)
In
In
::J
Q)
Q)
0..
In
~
~
~
....
(f)
0..
Q)
....
0
z
IBM 6361 Mag Card Unit
Customer Setup Guide
Order No. G544-2002-0
This form may be used to communicate your views about this publication. They will be sent to the
author's department for whatever review and action, if any, is deemed appropriate.
READER'S
COMMENT
FORM
IBM may use or distribute any of the information you supply in any way it believes appropriate with-
out incurring any obligation whatever. You may, of course, continue to use the information you supply.
Note: Copies of IBM publications are not stocked at the location to which this form is addressed.
Please direct any requests for copies of publications, or for assistance in using your IBM system, to your
IBM representative or to the IBM branch office serving your locality,
Possible topics for comments are:
Clarity Accuracy Completeness Organization Legibility
If you wish a reply, give your name and mailing address:
Number of latest Newsletter associated with this publication: _______________ _
Thank you for your cooperation. No postage stamp necessary if mailed in the U.S,A. (Elsewhere, an IBM
office or representative will be happy to forward your comments or you may mail directly to the address
in the Edition Notice
on the back of the title page.)

G544-2UU2-U
Reader's Comment Form
Fold and Tape
Please Do Not Staple
IIII
BUSINESS REPLV MAIL
FIRST CLASS
PERMIT NO 00040
AUSTIN. TEXAS
POSTAGE WILL BE PAID FOR BY ADDRESSEE
International Business Machines Corporation
Department 95H, Bldg. 998
11400 Burnet Road
Austin, Texas 78758
F old and Tape
NO POSTAGE
NECESSARY
IF MAILED
IN THE
UNITED STATES
[
::l
ct>
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
------------------------------------------------~
Fold and Tape
---
---
------
---
~ -~-
- - - ---
-------
-~-.-
®
I nternational Business Machines Corporation
Office Products Division
Parson's Pond Drive
Franklin Lakes, N. J. 07417
Please Do Not Staple
F old and Tape
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
I
s:
Q)
co
(')
Q)
a.
c
::J
;:;:
(')
c
~
o
3
(1)
~
en
(1)
r-+
C
"0
G>
c
0:
(1)
""0
~.
::J
r-+
(1)
0..
::J
C
en
»
G>
CJ1
.j:::o.
.j:::o.
~
o
o
'"
6

G544-2002 -0
---
---
---
-. ---
-- ---
--- -
-~- .
®
International Business Machines Corporation
Office Products Division
Parson's Pond Drive
Franklin Lakes, N.J. 07417
OJ
5:
(j)
w
(j)
()
c
<J)
.-+
o
3
!:1;
(/)
ct>
.-+
C
-0
G)
c
PIN 2684489
0:
ct>
-0
.....
:::J
C
(/)
»
G)
c..n
"""
""" r:..,
o
o
~
6