IBM 4764 User manual

4764 PCI-X Cryptographic Coprocessor
Installation Manual
򔻐򗗠򙳰

Note
Before using this information and the product it supports, read the information in “Safety and environmental notices” on page
ix and in “Notices,” on page 11.
Third Edition, September 2008
This edition describes installation of the IBM®4764 PCI-X Cryptographic Coprocessor.
IBM does not stock publications at the address given below. This and other publications related to the IBM 4764
Cryptographic Coprocessor can be obtained in PDF format from www.ibm.com/security/cryptocards.
Readers’ comments can be communicated to IBM by using the support link on the product Web site at
http://www.ibm.com/security/cryptocards, or by sending aletter to:
IBM Corporation
Department VM9A, MG81
Security Solutions and Technology
8501 IBM Drive
Charlotte, NC 28262-8563 USA
When you send information to IBM, you grant IBM anonexclusive right to use or distribute the information in any
way it believes appropriate without incurring any obligation to you.
©Copyright International Business Machines Corporation 2005, 2008. All rights reserved.
US Government Users Restricted Rights -Use, duplication or disclosure restricted by GSA ADP Schedule Contract
with IBM Corp.

Contents
Figures ....................................v
Tables .................................... vii
Safety and environmental notices ..........................ix
Safety notices ..................................ix
World trade safety information ............................x
Environmental notices ...............................xi
Product recycling and disposal ...........................xi
Battery return program............................... xii
IBM cryptographic coprocessor card return program.................... xiii
About this manual................................xv
How this manual is organized ............................xv
Where to find more information ...........................xv
Chapter 1. Introduction ..............................1
Contents of the coprocessor package .........................1
Special considerations for handling and storage......................1
Temperature ..................................1
Batteries ...................................1
Requirements and specifications ...........................2
Hardware requirement ..............................2
Software requirement ..............................2
Power requirement ...............................2
Environmental specifications ............................2
Physical dimensions ...............................2
Chapter 2. Installing the coprocessor.........................3
Chapter 3. Replacing IBM PCI-X cryptographic coprocessor batteries ............7
Appendix. Notices ................................11
Trademarks ..................................12
Electronic emissions ...............................12
Federal Communications Commission (FCC) statement .................12
Industry Canada compliance statement .......................13
Avis de conformité aux normes d’Industrie Canada ...................13
Japanese Voluntary Control Council for Interference (VCCI) statement ............13
Glossary ...................................15
Index .....................................17
iii

iv 4764 PCI-X Cryptographic Coprocessor Installation Manual

Figures
1. Jumpers on the PCI-X cryptographic coprocessor (front side) ...............4
2. Jumpers on the PCI-X cryptographic coprocessor (back side) ...............5
3. J10 connector and battery locations on the PCI-X cryptographic coprocessor .........9
v

vi 4764 PCI-X Cryptographic Coprocessor Installation Manual

Tables
1. Operating, storage, and shipping specifications ....................2
2. Jumpers on the PCI-X cryptographic coprocessor ...................5
vii

viii 4764 PCI-X Cryptographic Coprocessor Installation Manual

Safety and environmental notices
Safety notices
Safety notices may be printed throughout this guide. DANGER notices warn you of conditions or
procedures that can result in death or severe personal injury. CAUTION notices warn you of conditions or
procedures that can cause personal injury that is neither lethal nor extremely hazardous. Attention notices
warn you of conditions or procedures that can cause damage to machines, equipment, or programs. The
following DANGER notice appears in this manual:
DANGER
Electrical voltage and current from power, telephone, and communication cables are hazardous.
To avoid ashock hazard:
vDo not connect or disconnect any cables or perform installation, maintenance, or
reconfiguration of this product during an electrical storm.
vConnect all power cords to aproperly wired and grounded electrical outlet. Ensure outlet
supplies proper voltage and phase rotation according to the system rating plate.
vConnect any equipment that will be attached to this product to properly wired outlets.
vWhen possible, use one hand only to connect or disconnect signal cables.
vNever turn on any equipment when there is evidence of fire, water, or structural damage.
vDisconnect the attached power cords, telecommunications systems, networks, and modems
before you open the device covers, unless instructed otherwise in the installation and
configuration procedures.
vConnect and disconnect cables as described below when installing, moving, or opening
covers on this product or attached devices.
To Disconnect:
1. Turn everything OFF (unless instructed otherwise).
2. Remove power cords from the outlet.
3. Remove signal cables from connectors.
4. Remove all cables from devices.
To Connect:
1. Turn everything OFF (unless instructed otherwise)
2. Attach all cables to devices.
3. Attach signal cables to connectors.
4. Attach power cords to outlet.
5. Turn device ON.
(D005)
ix

The following CAUTION notice appears in this manual:
CAUTION:
Only trained service personnel may replace this battery. The battery contains lithium. To avoid
possible explosion, do not burn or charge the battery.
Do Not:
__ Throw or immerse into water
__ Heat to more than 100°C (212°F)
__ Repair or disassemble
Exchange only with the IBM-approved part. Recycle or discard the battery as instructed by local
regulations. In the United States, IBM has aprocess for the collection of this battery. For
information, call 1-800-426-4333. Have the IBM part number for the battery unit available when you
call. (C002)
World trade safety information
Several countries require the safety information contained in product publications to be presented in their
national languages. If this requirement applies to your country, asafety information booklet is included in
the publications package shipped with the product. The booklet contains the safety information in your
national language with references to the US English source. Before using aUS English publication to
install, operate, or service this IBM product, you must first become familiar with the related safety
information in the booklet. You should also refer to the booklet any time you do not clearly understand any
safety information in the US English publications.
x4764 PCI-X Cryptographic Coprocessor Installation Manual