Ice MONOPOLY ROLL-N-GO User manual

Installing the Marquee on top of three games.
Step 2:
Unlock the back covers from the left and
right mounts. Facing the back of the game,
the cabinet to the right will have the mount
that contains all the electronics.
The cabinet to the left will have the mount
with no electronics.
Step 1:
Position the two games leaving
1/2” between them at the front.
1/2”
1/2”

Step 3:
Secure the cabinet mounts to the top of the
cabinets. Use four AA6220 bolts and
AA6070 washers.
Make sure the mount with the
electronics are on top of the
cabinet on the left looking at
the front of the game
(right if from the back!).

Step 4:
Slide the right upper assembly over and onto the mounts as shown.
Step 5:
Secure it to the mounts using three AA6212 bolts and three AA6281 washers.
Attach harnesses shown.

Step 6:
Slide the left upper assembly over and onto the mounts as shown. Then secure using three
AA6281 bolts and three AA6212 washers. Attach harnesses shown.
Step 7:
At each side of the center display are the
mounting inserts. They are shown within the
circles. They insert into slots in each of the top
signs. One of those slots are shown.
Insert the center display into the two slots.

Step 8:
Secure the display using two AA6281 bolts and AA6212 washers.
Location is shown with the yellow circles with arrows.
Step 9:
Slide the sign onto the poles.
Attach harnesses shown.

Step 11:
Game 1: Computer connects to the DVI connection on the marquee, not the network line. The other
end of that cable should be Display port which connects to the computer in game 1.
A network switch is used to connect all the computers together. NOTE: There is a network connec-
tion on the marquee. THIS IS NOT TO BE INSTALLED INTO THE NETWORK SWITCH. Instead, a
network cable should go from the marquee to the center display at the center of the marquee, port
B. If you plug it into port A, the display will not work.

Step 12:
Attach the two wire channel covers. Carefully wire tie all wires and neatly tuck them inside this
channel. Secure the wire channel using two bolts and washers.
Software settings:
The game that you have the display port plugged into, go into game options and set under “system
settings”, machine ID =1, Mega Marquee ON. Then the other games should be set under system
settings, machine ID=2, then ID=3, both Mega Marquee should be turned OFF. Leaving this on will
cause an error to be displayed at the top left corner (Marquee disconnected).
We recommend that you set the game as follows. Standing in front of the game, the game on the
left should be game ID 1 and this is where you should plug the DVI connection into the PC. The
each game on the right should be one ID higher. So ID 2 is the middle game, ID 3 is the right most
game.
All settings then would be on ID1, and the two other games will clone whatever you set game ID1
to.