Ice MONOPOLY ROLL-N-GO User manual

Step 1:
Position the two games leaving
1/2” between them at the front.
1/2”
Installing the Marquee on top of two games.
Step 2:
Unlock the back covers from both mounts.
Facing the bck of the game, the cabinet to
the right will have the mount that contains all
the electronics. The cabinet to the left will
have the mount with no electronics.

Step 3:
Secure the cabinet mounts to the top of the
cabinets. Use four AA6220 bolts and
AA6070 washers.
Make sure the mount with the
electronics are on top of the
cabinet on the left looking at
the front of the game
(right if from the back!).
Step 4:
Slide the right upper assembly over and onto
the mount as shown.

Step 5:
Secure it to the mount using two AA6212
bolts and two AA6281 washers.
Step 6:
Slide the left upper assembly over and onto the mount as
shown. Then secure using two AA6281 bolts and two
AA6212 washers.
Attach the two harnesses together shown.
Attach the two harnesses together shown.

Step 7:
At each side of the center display are the
mounting inserts. They are shown within the
circles. They insert into slots in each of the top
signs. One of those slots are shown.
Insert the center display into the two slots.
Step 8:
Secure the display using two AA6281 bolts and AA6212 washers.
Location is shown with the yellow circles with arrows.
Step 9:
Locate the harnesses for the middle display and attached
the harnesses.

Step 9:
Slide the sign onto the poles.
Step 10:
Game 1: Computer connects to the DVI connection on the marquee, not the network line. The
other end of that cable should be Display port which connects to the computer in game 1.
A network switch is used to connect all the computers together. NOTE: There is a network
connection on the marquee. THIS IS NOT TO BE INSTALLED INTO THE NETWORK SWITCH.
Instead, a network cable should go from the marquee to the center display at the center of the
marquee, port B. If you plug it into port A, the display will not work.

Step 11:
Before attaching the wire channel cover, make sure all connections have been made. See below
for more details on wiring. Once confirmed, carefully wire tie all wires and neatly tuck them inside
this channel. Secure the wire channel using two bolts and washers.
Software settings:
The game that you have the display port plugged into, go into game options and set under “system
settings”, machine ID =1, Mega Marquee ON. Then the other game should be set under system
settings, machine ID=2. Mega Marquee option should be turned OFF. Leaving this on will cause an
error to be displayed at the top left corner (Marquee disconnected).
We recommend that you set the game as follows. Standing in front of the game, the game on the
left should be game ID 1 and this is where you should plug the DVI connection into the PC. The
game on the right should be one ID2. All settings then would be on ID1, and the other game will
clone whatever you set game ID1 to.