Locate a stud in the wall you intend to mount your arm on
and remove the wall mount from the box. Mark the top
hole, drill 11/64 pilot hole and insert an ICW provided
#14 screw and tighten slightly. Using a level, mark the two
lower holes and drill pilot holes, insert the last two #14
screws and, with the mount level, tighten all screws se-
curely.
Wallmount
Note:ICWsupplies#14 wood screws,ifinstallingontometal studs
youwillneedto replace withpropermetalstudfasteners. All
hardwareused to securewallmountmust have aproper
countersunkhead.
2
The wall mount is shipped
with the bearings wrapped and
it is recommended that you
leave the wrapping on until
later in the installation process.
