ICW Elite User manual

1) Do not attempt to adjust your Elite arm until everything you intend to mount to
the arm is mounted.
2) Arm must be completely horizontal (extended) before adjusting the arms tension.
Failure to do so will damage the arm and void the warranty.
3) Never loosen or remove any of the shoulder bolts. Doing so will cause the
arm to immediately come apart with tremendous force, and could cause seri-
ous injury.
4) If equipment requiringAC power is mounted to this unit, have a certified electri-
cian inspect the installation.
5) Failure to install this unit according to these instructions will void all ICW warran-
ties. If installed incorrectly, ICW is not liable for any damage or injury caused by
the unit.
ICW Elite SingleArm Ceiling Mount
DANGER!
The Elite arm contains high pressure gas springs.
The following cautions MUST be observed to
avoid serious injury.
Shoulder bolt

Removetheceiling mount fromthebox, and findthe4 #14 woodscrews
inyourhardwarebag. Firmlysecurethe ceiling mount toasolidstud
intheceilingusingall4oftheprovidedscrewsand being sure the mount is
level.
Loosenset screwand thread arm onto
ceilingmount,tightensetscrew.
Findthe screws inthe end covers
andthelongcover.
2

Removethelong arm coverbyunscrewing the 26-32flathead screws
usinga philipsheadscrewdriver.
Removethe end coversby unscrewingthe 2 10-24
flatheadscrewsusing the 1/8” hexkey.
Runthecordsalong the armalltheway
throughthe cordchannelupintotheceilingmount.
Replacethe three coverson the arm,being
carefulnotto pinch thecords.
Feedthecordsthroughtheplastic bushing
intheendcovers. The plastic bushing can
beremoved, openedand slippedover
cordif necessary.
3

YourT-REXmountcomeswithauniversal
VESAthatwillaccommodatea75mmor
100mmmonitor.
Usethe buttons to
adjustthe tilt
ofyourmonitor.
Liftgentlyonthe
monitortofree
buttonsfrom the
monitorsweight.
Onceyourmonitor is mounted, extendand
adjustthe tensiononthe arm
usingthet-handleadjustmentwrench
provided.
Adjustmentport.
Thankyou for yourpurchase ofan ICWTitan Elitearm. Any questions pleasecall 1-800-558-4435
Attachyourmonitortothe
T-REX mountusing the4mm
screws in yourhardware bag.
Usethesliderhandletomoveyourmonitoralong
thesliderail.