IEI Technology PulM-10G4SF-XL710 User manual

www.ieiworld.com
PulM Series
PulM-10G4SF-XL710
Networking Module Quick Installation Guide
SFI 10G x4
PCIe 3.0
PCIe 3.0 x8
A19
0
A32PCIe CONF. MODE
1One x8
Intel®XL710
SFP+
SFP+
SFP+
SFP+
A19
A32
Torx Screws x 2 Torx Wrench x 1
PulM-10G4SF-XL710
Package Contents PulM-10G4SF-XL710 Block Diagram
LAN LED Status
A32 A19
B
A32 A19
A
Slot A
PCIe Conguration
x4
x8
x4
Slot B
PCIe Conguration
x4
x2 x2 x2 x2
x4
A19 A32 PCIe Cong. Slot
0 0 4x2 B
0 1 2x4 A & B
1 0 1x8 A
PCH
CPU
Hardware Installation
Install the PulM-10G4SF-XL710 networking module into the slot of
the PUZZLE series. The Slot A supports 8 lanes from CPU (1 PCIe x8
or 2 PCIe x4); the Slot B supports 8 lanes from PCH (2 PCIe x4 or 4
PCIe x2). When the PulM-10G4SF-XL710 is installed in the Slot B, The
LAN ports function normally, but with half of the bandwidth.
Four PCIe x2 or
Two PCIe x4
One PCIe x8 or
Two PCIe x4
DMI GEN3 x4
Slot BSlot A
LAN Port
Speed
LED
Link
LED
LED State Description
Link (Right) Yellow Active
Speed (Left) Green 10Gbps data rate
Off 1 Gbps/100Mbps data rate

Networking Module Installation
Use the Torx wrench to remove the two Torx screws. Remove the slot cover. Save the slot cover screws.
Slide an IEI networking module into the slot until the module
is seated in the slot correctly and securely.
1
Step 2 Step
3
Step
Install the previously-removed Torx screws to secure the module
to the chassis.
4
Step