Inficon IRwin User manual

How to do a 1-point Calibration at 2.5vol% with your
IRwin Methane Leak Detector (Universal Mode)
(for a factory set unit)
QUICK START GUIDE
1 of 2
1
Make sure your IRwin is set in Universal Mode (see
the How to set your IRwin for Universal Mode quick
start guide)
mimh66en1-01 (1906)
Use to navigate to Calibration and press
3
4
5
Press followed by
If prompted, press and enter the Intermediate
password code. If not prompted, go ahead to next
step
2
Make sure your IRwin is set with the right calibration
settings (see the How to set your IRwin for one point
calibration 2.2% (2.5%) quick start guide)

www.inficon.com [email protected]
Due to our continuing program of product improvements, specifications are subject to change without notice.
All trademarks are the property of their respective owners.
©2019 INFICON mimh66en1-01 (1906)
How to do a 1-point Calibration at 2.5vol%
with your IRwin Methane Leak Detector
6
Press to get to the drop-down menu. Use to
navigate to Universal (low range) (2.5% CH4). Press
7
Expose the instrument to air and press
8
Expose the instrument to gas, 2.5% CH4, and press
9
When the calibratiation is done, press followed by
Then press followed by