Infinity IT-8500 User manual

B: ATTACHING THE LEGREST:
REMOVE THE LEGREST FROM ITS PACKAGING AND POSITION IT IN FRONT OF THE MAIN CHAIR BODY.
INSERT THE POWER CABLE TILL IT CLICKS,THEN INSERT THE AIR HOSE INTO THE BOTTOM AIR HOSE OPENING (THERE
ARE 2OPENINGS,THE TOP IS NOT USED AND HAS NO FUNCTION)

ON THE TOP LEFT AND RIGHT OF THE LEGREST ARE TWO BOLTS HOLES.INSERT THE HEX SCREW THROUGH THE BOLT
HOLES TO FASTEN ONE SIDE OF THE LEG REST TO THE BODY OF THE MASSAGE CHAIR.REPEAT ON THE OTHER SIDE.
NOW ZIP THE LEGREST TO THE SEAT CUSHION AND THE LEGREST IS COMPLETE.
C:ATTACHING THE BACK CUSHION:
ZIP THE TOP OF THE BACK CUSHION TO THE TOP OF THE BACKREST.WHILE LOOKING AT THE CHAIR FROM THE FRONT
THERE ARE THREE AIR HOSES IN THE BACK LEFT OF THE BACKREST CUSHION THAT NEED TO BE CONNECTED.BOTH
ENDS OF THE AIR HOSES ARE NUMBERED.CONNECT THE MATCHING NUMBERS TO EACH OTHER,5TO 5, 6TO 6, 11
TO 11.

WHILE LOOKING AT THE CHAIR FROM THE FRONT THERE IS ONE AIR HOSE AND ONE POWER CONNECTION IN THE
BACK RIGHT OF THE BACK CUSHION THAT NEED TO BE CONNECTED.CONNECT THE AIR HOSE 12 TO 12 AND CONNECT
THE POWER CABLE AS SHOWN
D:ATTACHING THE SPEAKER /AIRBAG UNITS:
THE SPEAKER UNITS ARE LABELED LFOR LEFT AND RFOR RIGHT AS IF YOU ARE SITTING IN THE CHAIR

CONNECT THE WHITE SPEAKER CONNECTOR TO THE WHITE CONNECTOR ON THE CHAIR.PUSH ON TILL IT CLICKS
INSERT THE 3JOINT PINS IN THE SPEAKER UNIT INTO THE THREE MATCHING CONNECTING TUBES ON THE CHAIR

AFTER THE JOINT PINS ARE FULLY INSERTED,MOVE THE SLIDER TO EXPOSE THE LOCKING SCREW.TIGHTEN THE
SCREW AND MOVE THE SLIDER BACK TO COVER THE SCREW
AFTER PLUGGING IN POWER CORD AND REMOTE CONTROL CORD TO THE BACK OF THE CHAIR YOUR INFINITY IT-
8500 IS READY FOR USE!