V1 ENGLISH 21-1041
SPECIFICATIONS
• Dimensions (H×W×D): 43.1 × 26.4 × 26.9 in. (109.5 × 67 × 68.5 cm)
• Weight: 37.9 lbs (17.2 kg)
• Maximum weight allowed: 275 lbs. (124.7 kg)
ONEYEAR LIMITED WARRANTY
Visit www.insigniaproducts.com for details.
CONTACT INSIGNIA:
For customer service, call 1-877-467-4289 (U.S. and Canada)
www.insigniaproducts.com
INSIGNIA is a trademark of Best Buy and its aliated companies.
Distributed by Best Buy Purchasing, LLC
7601 Penn Ave South, Richeld, MN 55423 U.S.A.
©2022 Best Buy. All rights reserved.
7Attach the chair back to the seat with three M8 × 25 mm screws (G). Tighten the bolts with the Allen
wrench (H).
8Turn the chair back/seat assembly right side up and attach it to the chair base by guiding the top of the
center support post (C) into the hole in the bottom of the riser mechanism (D).
CAUTION: Make sure that the chair back/seat assembly and chair base are securely connected and that all bolts
are tightened before sitting in the chair.
USING YOUR CHAIR
• To raise the height of the chair, lift the lever on the right side while not sitting in the chair. To lower the height
of the chair, raise the same lever while sitting in the chair.
• To lock the back of the chair, push the left lever backward. To unlock the chair, pull the left lever forward.
• Raise or lower the arms by pulling them up or pushing them down.
IMPORTANT SAFETY INFORMATION
Warnings:
• Fall hazard - Do not stand on the chair or attempt to use the chair as a ladder.
• Choking hazard - Be sure to properly dispose of all plastic packing bags.
• Fall hazard - Be careful not to lean the chair back so far that is causes the chair to fall backward or slip out from under you, or put all of your weight on
the front of the chair, causing it to fall forward.
Caution:
• Make sure that casters/wheels are fully inserted into the base of the chair.
• Always keep the base of the chair completely on the oor.
• Periodically make sure that the bolts holding the base and back of the chair in place are securely tightened.
Safety information
• Maximum weight capacity: 275 lbs. (124.7 kg).
• Read the Quick Setup Guide completely before assembly.
• Remove all parts from the carton and make sure that all parts are included prior to assembly.
• Assemble the chair on the carton or carpet to prevent scratching the chair.
• This chair is designed for sitting on the seat only and nothing else.
• Do not stand on or use as a step ladder.
• Do not sit on the armrests.
• This chair is designed for seating one person at a time.
• Tighten all screws, knobs, bolts, and parts rmly, otherwise do not use.
• If any parts are missing, damaged, or worn, stop using immediately.
• Do not use power tools.
39.2-43.1 in.
(99.5-109.5 cm)
13.4 in.
(34 cm)
14.6 in. (37 cm)
20 in. (51 cm)
25.2 in. (68.5 cm)
20 in. (51 cm)
Arms
Lift lever
Lever
