Intellinet 524117 User manual

GiGabit
EthErnEt
DEsktop
switch
usEr
manual
Models 524117
& 524124
INT-524117/524124-UM-0408-01
Model shown: 524124

Thank you for purchasing the INTELLINET NETWORK SOLUTIONS™
Gigabit Ethernet Desktop Switch, Model 524117 (5-port) or Model
524124 (8-port).
Providing your network with the high level of performance it needs to
handle quick transfer speeds to support disk mirroring, data backup,
graphics image le transfers and other bandwidth-intensive applications,
this handy device also utilizes broadcast storm control and the store and
forward switching method to ensure that your connections remain active
even under extremely busy conditions.
Easy-to-follow instructions in this user manual help make installation
of the switch quick and simple, so you’ll also soon be enjoying the
benets of these additional features:
• 10/100/1000 Mbps auto-sensing Auto MDI-X ports automatically detect
optimal network speeds
• High performance, half and full duplex, with zero packet loss
• Full ow control support provides optimum performance
• Auto-learning of network conguration
• Supports up to 4,096 MAC address entries
• Supports jumbo frames up to 4.6 kBytes
• 156 kBytes buffer memory
• Lifetime Warranty
FCC Warning
This device has been tested and found to comply with limits for a Class B
digital device, pursuant to Part 2 and 15 of FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates and radiates radio frequency energy and, if not
installed and used in accordance with the user’s manual, may cause
interference, in which case the user will be required to correct the
interference at his own expense.
CE Warning
This is a Class B product. In a domestic environment, this product may
cause radio interference, in which case the user may be required to take
adequate measures.
3

front panEl
The top-panel LED indicators — POWER, Link/Act — allow for more
convenient monitoring and troubleshooting of the switch. The table
below shows each LED function.
rEar panEl
All ports on the Gigabit Ethernet Desktop Switch support Auto-MDI/
MDI-X functionality, so crossover cables and uplink ports are not
needed for connections to PCs, routers, hubs, additional switches or
other devices. Cat5/5e UTP/STP cables provide optimal performance;
if a top-panel LED corresponding to any of the ports in use doesn’t
indicate a link or activity, check the connected device for proper setup
and operation.
4
LED Status Operation
POWER Steady green Power on
Off Check AC connection; turn the
power on
LINK/ACT Steady green Valid port connection
Blinking green Valid port connection; data being
transmitted/received
Off No link established

siDE panEl
Plug the female end of the power adapter rmly into the receptacle on
the side panel and the other end into an electrical outlet. Conrm that
the power LED is lit for a normal power status. NOTE: To ensure proper
operation, use only the power adapter included with the switch.
installation
Prior to use, it is recommended that the device be placed/positioned:
• on a level surface that can support the weight of the switch (and any
other items that need to be considered);
• with a minimum of 25 mm of clearance on the top and sides for
adequate ventilation;
• away from sources of electrical noise, such as radios, transmitters and
broadband ampliers; and
• where it cannot be affected
by excessive moisture.
5
Model 524124
Right: Sample
conguration
representing the
versatility of the
Gigabit Ethernet
Desktop Switch.

spEcifications
Standards
• IEEE 802.3 (10Base-T Ethernet)
• IEEE 802.3u (100Base-TX Fast Ethernet)
• IEEE 802.3ab (Gigabit Ethernet)
• IEEE 802.3x (Flow Control and Backpressure)
General
• ANSI/IEEE 802.3 NWay auto-negotiation
• Non-blocking, store and forward switching architecture
• Backpressure ow control for half duplex mode on 10/100 Mbps ports
• Connectors: 5 or 8 10/100/1000 Mbps RJ-45 ports
• Switch architecture: store and forward switch technology
• Network cables:
- 10Base-T: Cat3, 4, 5 UTP/STP
- 100Base-TX: Cat5 UTP/STP
- 1000Base-T: Cat5e UTP/STP
• Certications: FCC Class B, CE Mark, RoHS
Performance
• Filter/forward rate
- 10BaseT: 14,880 pps (packets per second)
- 100Base-TX: 148,800 pps (packets per second)
- 1000Base-T: 1,480,000 pps (packets per second)
• MAC address table: 4,096 entries
• Buffer size: 156 kBytes
• Jumbo frame support: 4.6 kB
LEDs
• Power
• LINK/ACT for each 10/100/1000 Mbps port
Power
• DC input: 5 V, 2 A (Model 524117); 5 V, 2.5 A (Model 524124)
• Power consumption: 10 Watts (maximum)
Environmental
• Plastic housing (ABS), desktop size
• Dimensions: 140 (W) x 105 (L) x 25 (H) mm (5.5 x 4.1 x 1.0 in.)
• Weight: 0.22 kg (0.5 lbs.)
• Operating temperature: 0 – 40°C (32 – 104°F)
• Operating humidity: 10 – 90% RH, non-condensing
• Storage temperature: -20 – 90°C (-4 – 194°F)
Package Contents
• Gigabit Ethernet Desktop Switch
• External power adapter
• User manual
6