Intermec CK1 Serial Dock User manual

What Is the Battery Charger? Charging Batteries Understanding the Lights
The CK1 Battery Charger (P/N 073660) is an accessory for the CK1 Handheld Computer. You
use the battery charger to charge the CK1 battery (P/N 073659).
This guide explains how to install and use the battery charger. Before using the battery
charger, please read this guide thoroughly and save it for future reference.
What You Need
To use the battery charger, you need one of the following AC power supplies:
You can charge the CK1 battery (P/N 073659) in the CK1 battery charger. The battery charger
fully charges the battery in about 5 hours.
This table explains what the different colors of the Charging and Power lights mean.
To charge batteries
•With the contacts on the battery aligned with
the contacts on the charger, slide the battery
into the slot.
The Charging light for that slot changes to green
or red to indicate the battery charge status. See
“Understanding the Lights” to learn what the
Charging light colors mean.
You must use the appropriate Intermec power supply with this device or
equipment damage may occur.
Attention: Vous devez utiliser la source d’alimentation Intermec
adéquate avec cet appareil sinon vous risquez d’endommager
l’équipement.
CK1 Battery Charger Quick Start Guide
Region Part Number
Australia 073855
Europe 073853
United Kingdom 073852
United States 073854
Light Color Description
Charging Red
Green
The battery charger is charging the battery.
The battery is fully charged.
Power Off
Green
The battery charger is not receiving power. Make sure the AC
power supply is connected properly.
The battery charger is connected to AC power and is ready to
charge.
Power
light
Battery
contacts
Charging
light

Heading 1
Specifications
Installing the Battery Charger Specifications
Quick Start Guide
CK1 Battery Charger
CK1 Battery Charger Quick Start Guide
*073776-001*
P/N 073776-001
1
2
Place the battery charger on a flat, stable, and clean surface that is within 1.5 m (5
ft) of an AC power outlet.
Connect the AC power supply to the power supply connector on the battery
charger and to an AC power outlet. The Power light turns on, showing that the
battery charger is ready to use.
To prevent fire or electric shock, do not expose the battery charger to rain or
moisture.
Avertissement: Pour éviter des risques d’incendie ou de choc électrique, ne
pas exposer le chargeur de batterie à la plui ou l’humidité.
You may need additional information when working with the CK1 and battery charger in a
data collection system. Please visit our web site at www.intermec.com to download PDF files
of our current manuals. To order printed versions of the Intermec manuals, contact your local
Intermec representative or distributor.
For More Information
Power
supply
connector
Power
light
Battery
contacts
Charging
li
g
ht
Input Voltage: x 6V
Current: 400 mA
Operating Temperature: 5°C to 40°C (41°F to 104°F)
Storage Temperature: -20°C to 70°C (-4°F to 158°F)
Operating Humidity: 0% to 95% non-condensing relative humidity
6001 36th Avenue West
Everett, WA 98203
U.S.A.
www.intermec.com
© 2004 Intermec Technologies Corp.
All Rights Reserved