Intermec 700 Series User manual

700 Series Modem Dock Quick Start Guide
-2
Single Modem Dock
Serial portRJ-11 port Power jack
DCD--Data Carrier Detect
RX--Receive
DTR--Data Terminal Ready
TX--Transmit
The 9-pin Serial port (COM B) can not be
used at the same time as the Modem
(COM A) port. These two ports share com-
mon serial interface lines to the 700 Se-
ries Mobile Computer. The 700 Series Col-
or Mobile Computer can switch between
the two ports via a signal called A/B
Switch. The modem is the default port.
The 700 Series Monochrome Mobile Com-
puter does not have A/B switching capa-
bility and can only use the modem port.
Software to control the A/B switching is

700 Series Modem Dock Quick Start Guide
-3
included in the 700 Color Software Tools
CD-ROM.
AT Commands
Default setting is AT+GCI=B5, which includes
the following countries:
"Belgium, Canada, Chili, Cyprus, Denmark,
Finland, France, Germany, Greece, Iceland,
Ireland, Italy, Korea, Liechtenstein, Luxem-
bourg, Netherlands, Norway, Portugal, Spain,
Sweden, Switzerland, Turkey, United King-
dom, and the United States.
To alter the country code, use the following mo-
dem command string: AT+GCI=B(X)
“X” = country identification code, shown below:
"Non-Default List
Country ID Code
Argentina 1
Australia 9
Hungary 99
Japan 10
New Zealand 3
Poland 99
Singapore 99
Taiwan 2
Once changed, the country code change remains
set to that specific country code until it is inten-
tionally reset.
Power Supply Cord Routing
1. Remove adhesive dock feet from the
box and place on bottom of dock.
2. Route power cord as shown in il-
lustration.

700 Series Modem Dock Quick Start Guide
-4
Power supply
Routing power supply cord
Bottom of unit
Safety Warnings
English
"For use only with Intermec 700 Series mono-
chrome and color Mobile Computers.
"Use 26 AWG or larger telephone wire to re-
duce the risk of fire.
"Never install telephone wiring during a light-
ning storm.
"Never install a telephone jack in a wet loca-
tion unless the jack is specifically designed for
wet locations.
"Never touch uninstalled telephone wires or
terminals unless the telephone line has been
disconnected at the network interface.
"Use caution when installing or modifying tele-
phone lines.
"Avoid using a telephone during an electrical
storm; there is the remote risk of electrical
shock.
"Do no use a telephone in the vicinity of a gas
leak.
French
Consignes de sécurité
"À utiliser seulement avec les ordinateurs mo-
biles monochromes et couleur de la gamme
Intermec Série 700.

700 Series Modem Dock Quick Start Guide
-5
"Utiliser un fil téléphonique de calibre 26 ou
plus grand afin de réduire les risques d’incen-
die.
"Ne jamais installer de câblage téléphonique
pendant un orage électrique.
"Ne jamais installer de prise téléphonique dans
un endroit humide à moins que la prise ait été
spécifiquement conçue pour être utilisée dans
les endroits humides.
"Ne jamais toucher les fils de téléphone ou de
l’équipment terminal non isolés à moins que la
ligne téléphonique n’ait été débrancher de l’in-
terface réseau.
"Faire preuve de prudence en installant ou en
modifiant des lignes téléphoniques.
"Éviter d’utiliser un téléphone pendant un
orage électrique ; il existe un faible risque de
choc électrique.
"Ne pas utiliser un téléphone situé à proximité
d’une fuite de gaz.
Serial Connector
Pin 1
Pin 9
Serial 9-Pin Connector
Pin-outs for Modem Dock
Pin Number Signal
1DCD
2RxD
3Txd
4DTR
5 Ground
6DSR
7RTS
8CTS
9 Not used

700 Series Modem Dock Quick Start Guide
-6
Product Warranty
We warrant that Intermec Technologies Corporation
products will be free from defects in manufacturing
materials and workmanship for one (1) year from
date of shipment to you.
Conditions of warranty
1. Purchaser must obtain a Return Authoriza-
tion (RA) number from the Intermec Service
Center (1--800--755--5505) within the warranty
period.
2. Purchaser will provide a written, detailed de-
scription of the defect.
3. The product must be promptly returned to the
designated Intermec Service Center, freight
prepaid by Purchaser.
4. Upon examination of the product, Intermec
must agree that the defect exists and is cov-
ered by this warranty. Warranty repairs will
be completed at the Service Center and re-
turned to the Purchaser by prepaid surface
freight.
The foregoing is a summary of the standard warranty,
which shall be purchaser’s sole remedy. Complete
warranty details can be found in your purchase
agreement or obtained from your local Intermec sales
office.
In no event shall Intermec Technologies Corporation
nor its suppliers be liable for any special, consequen-
tial or incidental damages.
700 Series Color Mobile Computer Modem Dock-Quick Start Guide
*962040007*
962040007 REV A
June, 2002
www.intermec.com