Invacare IH5125 User manual

User Manual
DEALER: This manual MUST be given to the user of the product.
USER: BEFORE using this product, read this manual and save for future
reference.
Part No 008187 1Overbed Table
Overbed Table
IH5125 Overbed Table
IH 5126 Overbed Table with Vanity
1 General
1.1 Symbols
Signal words are used in this manual and apply to hazards or unsafe practices which could result in
personal injury or property damage. See the information below for definitions of the signal words.
2 Safety
2.1 Weight Limitation
The weight limitation of the IH5125 and IH5126 is 40 pounds.
2.2 General Warnings
WARNING Warning indicates a potentially hazardous situation which, if not avoided, could result in death or
serious injury.
!IMPORTANT
Indicates a hazardous situation that could result in damage to property if it is not avoided.
Gives useful tips, recommendations and information for efficient, trouble-free use.
Check ALL parts for shipping damage. If shipping damage is noted, DO NOT use. Contact
carrier/dealer for further instruction.
WARNING DO NOT USE THIS PRODUCT OR ANY AVAILABLE OPTIONAL EQUIPMENT WITHOUT
FIRST COMPLETELY READING AND UNDERSTANDING THESE INSTRUCTIONS AND
ANY ADDITIONAL INSTRUCTIONAL MATERIAL SUCH AS OWNER’S MANUALS,
SERVICE MANUALS OR INSTRUCTION SHEETS SUPPLIED WITH THIS PRODUCT OR
OPTIONAL EQUIPMENT. IF YOU ARE UNABLE TO UNDERSTAND THE WARNINGS,
CAUTIONS OR INSTRUCTIONS, CONTACT A HEALTHCARE PROFESSIONAL, DEALER
OR TECHNICAL PERSONNEL BEFORE ATTEMPTING TO USE THIS EQUIPMENT -
OTHERWISE, INJURY OR DAMAGE MAY OCCUR.
Get other manuals https://www.bkmanuals.com

Overbed Table 2Part No 008187
3 Assembling the Overbed Table
1. Position the column assembly on the base.
2. Assemble the column assembly to the base with the two locknuts provided and tighten securely.
3. Using extreme caution, push down on the outer column and remove the packing pin from the
column assembly as shown in Detail “A”.
4. Allow the column assembly to expand slowly.
5. Position the table top on the column assembly and tighten securely with the six Phillips®screws
provided.
FIGURE 1 Assembling the Overbed Table
4 Using the Overbed Table
1. Lift up on the handle on the side of the overbed table and adjust the overbed table to the desired
height.
2. When the table is at the desired height, release the handle.
ACCESSORIES WARNING Invacare products are specifically designed and manufactured for use in conjunction with Invacare
accessories. Accessories designed by other manufacturers have not been tested by Invacare and
are not recommended for use with Invacare products.
WARNING ALWAYS wear safety glasses and use extreme caution when removing the packing pin from the
column assembly of the overbed table. The column assembly is spring loaded and will extend
suddenly when the packing pin is removed. Serious injury or damage can occur.
After any adjustments, repair or service and before use, make sure that all attaching component
parts are secure.
For this procedure, refer to FIGURE 1.
For this procedure, refer to FIGURE 2.
Phillips Screws
Locknuts
Column
Assembly
Push Down with
this Hand Packing Pin
Table Top
Top View of
Column Assembly
Base
DETAIL “A”
Get other manuals https://www.bkmanuals.com

Part No 008187 3Overbed Table
FIGURE 2 Using the Overbed Table
5 Limited Warranty
PLEASE NOTE: THE WARRANTY BELOW HAS BEEN DRAFTED TO COMPLY WITH FEDERAL LAW APPLICABLE
TO PRODUCTS MANUFACTURED AFTER JULY 4, 1975.
This warranty is extended only to the original purchaser/user of our products.
This warranty gives you specific legal rights and you may also have other legal rights which vary from state to state.
Invacare warrants its product to be free from defects in materials and workmanship for one year for the original purchaser. If within such
warranty period any such product shall be proven to be defective, such product shall be repaired or replaced, at Invacare’s option with
refurbished or new parts. This warranty does not include any labor or shipping charges incurred in replacement part installation or repair of
any such product. Product repairs shall not extend this warranty - coverage for repaired product shall end when this limited warranty
terminates. Invacare’s sole obligation and your exclusive remedy under this warranty shall be limited to such repair and/or replacement.
For warranty service, please contact the dealer from whom you purchased your Invacare product. In the event you do not receive
satisfactory warranty service, please write directly to Invacare at the address on the back page. Provide dealer’s name, address, model
number, date of purchase, indicate nature of the defect and, if the product is serialized, indicate the serial number. Invacare Corporation will
issue a return authorization. The defective unit or parts must be returned for warranty inspection using the serial number, when applicable,
as identification within thirty days of return authorization date. DO NOT return products to our factory without our prior consent. C.O.D.
shipments will be refused; please prepay shipping charges.
LIMITATIONS AND EXCLUSIONS: THE WARRANTY SHALL NOT APPLY TO PROBLEMS ARISING FROM NORMAL WEAR OR
FAILURE TO ADHERE TO THE ENCLOSED INSTRUCTIONS. IN ADDITION, THE FOREGOING WARRANTY SHALL NOT APPLY
TO SERIAL NUMBERED PRODUCTS IF THE SERIAL NUMBER HAS BEEN REMOVED OR DEFACED; PRODUCTS SUBJECTED TO
NEGLIGENCE, ACCIDENT, IMPROPER OPERATION, MAINTENANCE OR STORAGE; OR PRODUCTS MODIFIED WITHOUT
INVACARE’S EXPRESS WRITTEN CONSENT INCLUDING, BUT NOT LIMITED TO: MODIFICATION THROUGH THE USE OF
UNAUTHORIZED PARTS OR ATTACHMENTS: PRODUCTS DAMAGED BY REASON OF REPAIRS MADE TO ANY COMPONENT
WITHOUT THE SPECIFIC CONSENT OF INVACARE; PRODUCTS DAMAGED BY CIRCUMSTANCES BEYOND INVACARE’S
CONTROL; PRODUCTS REPAIRED BY ANYONE OTHER THAN AN
INVACARE DEALER, SUCH EVALUATION SHALL BE SOLELY DETERMINED BY INVACARE.
THE FOREGOING WARRANTY IS EXCLUSIVE AND IN LIEU OF ANY OTHER EXPRESS WARRANTIES, IF ANY, INCLUDING THE
IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. IT SHALL NOT EXTEND BEYOND
THE DURATION OF THE EXPRESSED WARRANTY PROVIDED HEREIN AND THE REMEDY FOR VIOLATIONS OF ANY IMPLIED
WARRANTY SHALL BE LIMITED TO REPAIR OR REPLACEMENT OF THE DEFECTIVE PRODUCT PURSUANT TO THE TERMS
CONTAINED HEREIN. INVACARE SHALL NOT BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES
WHATSOEVER.
THIS WARRANTY SHALL BE EXTENDED TO COMPLY WITH STATE/PROVINCIAL LAWS AND REQUIREMENTS.
Handle Height
Adjustment
Get other manuals https://www.bkmanuals.com

Invacare Continuing Care, Inc. www.invacare-ccg.com
USA and Canada:
One Invacare Way
Elyria, Ohio USA
44036-2125
For Customer Service,
call 800-668-2337
Invacare Continuing Care, Inc.
A subsidiary of Invacare
Corporation.
Manufacturing
Location:
2101 E. Lake
Mary Blvd
Sanford, Florida
USA
32773
© 2010 Invacare Corporation. All
rights reserved. Republication,
duplication or modification in whole
or in part is prohibited without prior
written permission from Invacare.
Trademarks are identified by ™ and
®. All trademarks are owned by or
licensed to Invacare Corporation or
its subsidiaries unless otherwise
noted.
Phillips is a registered trademark of
Phillips Screw Company.
Part No 008187 Rev D - 4/10
Get other manuals https://www.bkmanuals.com