Invacare Matrx SAHMINI User manual

Installation Manual
Mini Swing
Away Laterals
for the
Invacare-Matrx
Mini Back
(model #: SAHMINI)
DEALER: This manual contains installation & adjustment instructions specific to
Motion Concepts Mini Swing-Away Laterals. This Manual MUST be given to
the user of the product.
BEFORE using this product, please read through the instructions carefully
and save for future reference.
TRD0450 Rev A

If you have any questions or concerns during the installation of the Mini
Swing-Away Laterals, please contact our Technical Sevice Department
for assistance:
Canada: 800-680-4191 USA: 888-433-6818
Installation Overview: Mini Swing-Away Lateral (SAHMINI)
T-Nut (M5)
Flat
Washer
Button Socket
Cap Screw
(M5 x 10mm)
1Prior to installation, the outer cover must be removed from the Matrx
Mini back shell. To remove, disengage the bottom*of the cover from
the hook & loop fasteners and pull cover away from the back shell.
(*The upper portion of the cover can remain attached)
2 Working on one side of the back shell, align the vertical slots in the
lateral mounting bracket with the horizontal slots in the back shell and
loosely install the bracket onto the inside of the back shell using the
hardware provided (see Installation Overview above).
3Loosely install the remaining lateral mounting bracket on the opposite
side of the back shell.
4Install the Lateral Pads (x2) (sold separately) onto the lateral pad
mounting plates using the hardware provided.
5Adjust each lateral bracket to the desired position (width and height),
on the back shell, then fully tighten the mounting hardware.
(note: The position of the lateral pad can also be adjusted to the
desired depth/angle on each mounting plate)
6With both Mini Laterals properly installed/adjusted, re-install the outer
cover onto the back shell.
Installation Instructions:
Lateral Pad (EPAD-XS)
(sold separately)
Lateral Mounting
Bracket
(Note: Left Lateral Assembly Shown)
Mini Lateral Installation Overview:
Lateral Pad
Mounting
Plate

Mini Lateral Adjustments:
Mini Swing-Away Lateral (SAHMINI) Adjustments:
Lateral Mounting
Bracket
Lateral Pad
Mounting Plate
Pad depth
adjustment
1.5” (38mm)
width
adjustment
1.25” (32mm)
Depress latch to release
the swing-away lateral
latch
release
Swing-Away Feature:
(pad sold separately)
height
adjustment
2.25” (57mm)