INVT Goodrive 800 Series User manual

Installation and Maintenance Manual
8Series
109456, Москва, 1-й Вешняковский пр-д, д.2
Тел.: [phone], доб. 203
отдел продаж: [e-mail]
тех. поддержка: [email protected]
www.invt.su

Cross section of optical fiber

3-phase
power supply
Inverter
Inverter
Inverter
Inverter
Inverter

Inverter
Inverter
Inverter
Inverter
Inverter
Inverter

Forklift Forklift
Fender
Side
Side
Center of
Gravity
Center of
Gravity

Top view
Side view
The space can be used for the layout of cable channel.
Avoid cooling air enters into the cabinet
body via the chassis in the cable channel.
To guarantee the protective degree, please
use the original chassis delivered along with
the inverter. If users matches their own I/O
cable boards, pay attention to the requirements
of protective degree, fireproofing and EMC.
Cable
75
500
450~500mm
75

(Mounting hole)
2- 4Φ1

(Mounting hole)
4- 4Φ1

(Foundation bolt hole)
(Foundation bolt hole)
6-Φ15
18-Φ15

M6 assembled
bolt
Rear door
(Note1)
Note1: If necessary, remove the door.
Protective plate M6 assembled bolt
(Foundation bolt hole)
M10 fastening bolt
Connect power supply
Location of cable tie
Connect motor
M10 fastening bolt
Grounding copper bar
6-Φ15

Rear door
(Note1)
M6 assembled
bolt
Note1: If necessary, remove the door.
M12 fastening bolt M12 fastening bolt
Connect power supply
Location of cable tie
Connect motor
Grounding copper bar

(Foundation bolt hole)
M6 assembled bolt
M6 assembled bolt
Rear door (Note1)
Note1: If necessary, remove the door. Protective plate
11-Φ15

Inverter unit
Output terminal of inverter unit
Holes for output cables
Input terminal of AC power supply
M10 fastening bolt
Output terminals of
primary loop M12 bolt hole
Behind Front
Connect motor
M12 fastening bolt
Grounding copper bar
Location of cable tie
Connect power supply
Side of inverter
Front of incoming cabinet