inVue PL601 User manual

Remove the battery pull tab.
4
Smart Lock
OneKEY Padlock
PL601
2With the padlock in the unlocked state
turn the back cover counterclockwise to
align the scribe mark to the “unlocked”
icon.
Remove the back cover from
padlock.
3
6Rotate the back cover so that the
scribe mark will align to the “locked”
icon.
7Installation:
Rotate the lock shackle out so that it
will t into the latch.
5Replace the back cover, aligning the
scribe mark with the “unlocked” icon.
1First Time Usage:
Pull the lock shackle from the lock body.

9Swivel the lock body to the shackle
and close the lock to secure the
latch.
13 Insert the new CR2450 battery,
paying attention to the polarity of
the battery and the port (“+” to “+”,
“-” to “-”).
14 With the battery inserted, place a
charged and coded OneKEY against
the lens on the front of the padlock
and press the button.
12 Lock Jump Process & Battery
Replacement:
If the padlock has been in place
long enough for the battery to die,
rendering the padlock inoperative,
begin by opening the small access
panel on the bottom of the lock body.
10 Removal:
To unlock the padlock, place a
charged and coded OneKEY against
the lens on the front of the padlock
and press the button.
11 Pull down on the lock body. The
lock will automatically relatch in 10
seconds. Remove the lock to gain
access to the latch.
15 Pull down on the lock body once you
hear the mechanism activate.
8Fit the shackle through the latch.

© 2020 InVue Security Products Inc. All rights reserved.
InVue is a registered trademark of InVue Security Products.
SD0768 Rev0 07/20/20
www.invue.com
NA / LATAM // 704.752.6513 •888.55.INVUE
EMEA // +31.23.8900150
APAC // +852.3127.6811
17 Remove the back cover as shown in
Steps 1 & 2.
18 Remove the old battery. 19 Insert the new battery paying
attention to the polarity of the battery
and the port (“+” to “+”, “-” to “-”).
20 Replace the back cover as shown
in steps 5 & 6. The padlock is now
ready to be reused.
16 Remove the lock from the latch.