inVue L410 User manual

Move the inner panel out to have
access to the hidden edge of the
inner glass panel.
L410 Lock
PL801
3
4
Slide strike plate over the edge of
inner panel. Tighten screw.
2Open the outer panel fully.
1Fully close both glass panels and
identify the inner glass panel.
7
Slide lock housing completely onto
strike plate. Conrm lock housing is
pushed against edge of outer panel.
6
Seperate outer cover from lock
housing.
Outer Cover
Lock Housing
5
Fully close both glass panels.
Hidden Edge
Hidden Edge
Inner Panel
Hidden Edge

9
Press outer cover against outer
glass panel to hold in place and
pull adhesive tab. Press and hold
adhesive against outer glass panel for
10 seconds.
© 2016 InVue Security Products Inc. All rights reserved.
InVue is a registered trademark of InVue Security Products.
SD0383 Rev2 01/04/2017
www.invue.com
NA / LATAM // 704.752.6513 •888.55.INVUE
EMEA // +31.23.8900150
APAC // +852.3127.6811
8
Slide outer cover onto lock housing
until it rests against the surface of the
outer glass panel.
2
Within 3 seconds after key beep,
open the outer glass panel using the
L410 outer cover as a handle.
3
To lock the L410 slide the glass
panels closed. The L410 will self latch
into the locked position.
To unlock the L410 press IR2 or
IR3 key into IR lens on front of lock
housing and press the button. Wait
for the IR2 or IR3 key to beep before
removing key from IR lens.
1
Use:
Note: If the key does not beep and
makes a knack-knack sound it means
the key was pulled away too soon.
Try again and wait for the beep before
pulling key away.
10 Use screw driver provided to tighten
set screw on outer cover. Do not over
tighten.