IPC CT51-71 R User manual

This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
CT51-71 R Quick guide
1
4
2 3
5 6
7 8
PLDC04369
PUSH
PUSH
SET
ON
ECO
AUTO
CHEM
H
2
O
+
PUSH

REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Brush attachment, t the rollers in their housing by rst inserting them on the drive pulley, then pushing them upwards until they click into place.
Brush removal, release the brushes by pulling them downwards from the side opposite the drive pulley, then extracting them from their housing.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check that the suction lter
and dirt lter are clean.
Check that the
detergent outlet lter
is clean.
Check that the
squeegee is clean
and the blades are not
worn.
Check that the brushes are
clean. Replace if necessary.
PLDC04369
1
2
FILTER
BATTERY CHARGER ON BOARD
BATTERY CHARGER STAND ALONE
24V