IPC CT105 User manual

CT105 Quick guide
This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
1
5
2 3
6
7 8 9
4
PLDC03891
ON
CHEM
H2O
+
P

REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSHES
Open the clip (Ref. 1).
Remove the two blade retainers (Ref. 2) by pushing them outwards then extracting them.
Remove the blade.
Reuse the same blade by reversing the edge in contact with the oor until all four edges are worn out, or replace with a new blade, tting it onto the
screws on the body of the squeegee.
Reposition the two blade pressing devices by centering the wider part of the slots on the squeegee body fastening pins, then push the blade pressing
devices inwards.
Close the hook again.
Replace the squeegee on its support, following the instructions described previously.
Attaching:
insert the brushes under the head, making sure they rest against the aligners. Hold the button down to lower the head until the brushes are engaged.
Releasing:
lift the head using the lift button, then press the release button.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check the suction lter is
undamaged and clean.
Check that the
detergent outlet lter
is clean.
Check that the
brushes are
clean. Replace if
necessary.
Check that the
squeegee is clean
and the blades are not
worn.
Check the detergent tank
ll lter is undamaged and
clean.
PLDC03891
1
2
FILTER
BATTERY CHARGER
STAND ALONE
24V
2
1