IPC CT15 B User manual

This guide is intended for quick consultation only and does not replace the user and maintenance manual.
Before using the machine, read the user and maintenance manual contained in the machine’s packaging thoroughly and strictly follow all the
instructions.
PREPARATION & OPERATION
CT15 B Quick guide
1
6
2 3
9
5
7 8
PLDC01957
ON
AUTO
ECO
ECO
CHEM
H
2
O
+
> 3”

REPLACING THE SQUEEGEE BLADES
ATTACHING/REMOVING THE BRUSH
• unscrew the nuts xing the blade retainers;
• remove the two blade retainers;
• remove the blade;
• put the same blade back, reversing the edge in contact with the oor until all four edges are worn, or replace with a new one;
• put the two blade retainers back on the squeegee and screw up the nuts again;
Attaching the brush:
• rest the brush on the oor in front of the machine. Raise the front of the machine by levering on the handle, then lower it onto the brush, centring it with the brush cover. Action the drive lever repeatedly until the brush
engages..
Removing the brush:
• Raise the front of the machine by levering on the handle, then operate the brush lever repeatedly. After operating the lever a few times, the brush is released and falls to the ground.
DAILY MAINTENANCE
Clean the dirty
water tank.
Check the dirty water tank oat
is undamaged and clean and
moves freely on the pin.
Check that the
detergent outlet lter
is clean.
Check that the brush is clean.
Replace if necessary.
Check that the
squeegee is clean
and the blades are not
worn.
PLDC01957
BATTERY
CHARGER ON
BOARD