Jabra GN9330e - USB - Headset User manual

How to connect my Jabra GN9330e with Aastra Open Phone
63 and 65
Jabra GN9330e
Prerequisite:
Jabra GN9330e + Jabra 8800-00-93 + AZ – Adapter (available from Aastra /
DeTeWe)
In combination with one of the following phones:
Open Phone 63 / 65
System:
Open Com 100 from Software 5.2
Open Com 1000 from Software 3.2
Connection:
1. Insert the supplied RJ9 to RJ9 connection cable into the socket of the
Jabra GN9330e base marked with the "phone" symbol and the other
end into the "handset" socket of the AZ adapter.
2. Now insert the 8-pin RJ45 plug of the Jabra 8800-00-93 connection
cable into the Jabra GN9330 base socket marked "AUX".
3. Please connect the receptacle connector to the AZ adapter socket
marked with the "bell" symbol and insert the 6-pin modular plug into
the "second handset" socket of the AZ adapter.
Software setup:
Put the headset into the base and activate the "RHL mode".
Hold down the "phone" button on the base of the Jabra GN9330e for
24/04/2021 11:16
https://www.jabra.co.uk/supportpages/jabra-gn9330e/9337-508-402/faq/29f778e6-d8bf-
4e0a-baea-a315459d0cc9
Page 1 of 3

approx. 6 seconds until the online display (blue LED) on the headset starts
to flash. The current software is displayed to you by activating the volume
controller in the form of the charge display (green LED).
Now you can switch between the different software modes (LED 1-4) by
using the "volume" up/down controller on the headset. To confirm the
software has successfully installed, the base automatically switches back
to charge mode after approx. 10 seconds.
LEDs from left to right:
LED 1 = RHL
LED 2 = DHSG
LED 3 = AEI
LED 4 = MSH
Base setup:
Set the phone setup switch to "A"".
Microphone level setup:
For this, call someone.
Now adjust the grey volume dial on the Jabra GN9330 base until you can
be understood clearly.
24/04/2021 11:16
https://www.jabra.co.uk/supportpages/jabra-gn9330e/9337-508-402/faq/29f778e6-d8bf-
4e0a-baea-a315459d0cc9
Page 2 of 3

Phone setup:
Activate the "Remote Headset" function (new DECT headset) in your
OpenPhone phone.
Please enter the following key sequence into your Open Phone 63/65:
> MENU> SETTING> PERIPHERALS > Additional Phone Selection >
"Remote Headset" (new DECT headset)
Headset answer/end:
As soon as the dial tone signal can be heard in the headset, you can answer
the call by pressing the "answer/end"button on the headset; by pressing
again the call is ended.
24/04/2021 11:16
https://www.jabra.co.uk/supportpages/jabra-gn9330e/9337-508-402/faq/29f778e6-d8bf-
4e0a-baea-a315459d0cc9
Page 3 of 3