JACKRABBIT BOX CONTENTS
1. JackRabbit micro ebike
2. 110 volt AC input battery charger
3. Charging adapter (only needed if
charging battery outside of bike).
ASSEMBLY INSTRUCTIONS
Your JackRabbit is pre-assembled and
requires a few steps to get it ready to ride.
1. Remove all contents from the carton
(including battery charger). Cut any zip ties
and remove packaging padding.
2. Push black rubber “+” button above front
wheel. Rotate front wheel 180 degrees.
3. Insert the handlebars into the stem hole
until the silver pin under the “+” button on
the stem clicks in place.
4. Turn knob on handlebar clamp clockwise
to tighten and then push clamp towards
stem to lock in place.
5. Squeeze the brake lever to confirm that the
brake pads contact the rotor.
6. Set seat height so feet are flat on the
ground when seated. Tighten the seat post
clamp the same way as handlebar clamp.
7. Fold down the footrests.
8. Check the tires’ air pressures. All tires lose
air pressure over time. 40 psi is the
minimum. Inflating to 65 psi (maximum)
will result in lower rolling resistance and
increased battery range.
FIRST RIDE GUIDANCE
(Learning to ride JackRabbit is easy.)
First: top up the battery by plugging charger
into the JackRabbit underneath at the front
and add air to the tires.
Start out using it like a child’s balance bike:
• Before riding, test out the brake.
• Simply push with your legs and glide.
• Ride with the balls--not heels or arches--
of your feet on the footrests.
• You’ll be surprised how fast you can
coast and glide on flat ground.
• Sit comfortably and try not to lean on the
handlebars -just use them for steering.
• Use your legs as shock absorbers by
pressing down through your feet and
lifting your tush off the seat.
After you get a feel for the braking and
handling characteristics:
• Push the grey button on the throttle
control to turn on the power.
• With both hands on the handlebars
lightly push your thumb down on the
throttle. Just a little bit at first!
• Release your thumb anytime to coast.
• Not much throttle is needed. “Pulsing”
and glide-coasting is the best way.
• You can quickly and easily put both feet
on the ground at any time--something
you can’t do on a bicycle or scooter.
HOT TIPS & TRICKS
Charge the battery in the JackRabbit by
plugging the charger directly into the
JackRabbit underneath it near the front.
The keys are for removing the battery, which is
only necessary if you have an extra battery or
are taking your JackRabbit on an airplane.
Separate the keys and store one in a safe place
as a backup. Lost keys are not replaceable!
The adapter that comes with the charger is only
needed for charging spare batteries.
To remove the battery for using a spare battery
or when flying with JackRabbit: insert key
underneath, turn 90 degrees, and then use two
hands to gently pull the battery straight up.
To insert a spare battery, make sure a key is
inserted underneath then use both hands to
lower battery straight down. Jiggle a bit to
insert until battery top is flat on top of
JackRabbit. No pressure is needed! Do not use
force! Once fully inserted, rotate & remove key.
To fit JackRabbit into a car trunk, rotate front
wheel. Watch our videos to see how!
Try Walk Mode! Watch our videos to see how!
Buy cool accessories at www.jackrabbit.bike
Ride safe, be respectful of others around you
when riding, and HAVE FUN!
