Jason.L Blackjack Premium Rectangle Boardroom Table User manual

ASSEMBLY INSTRUCTIONS
Page 1 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Tools Required: Power screwdriver.
2 persons required for installation
Special Note: No pre-drilled holes or nut inserts are
provided. Wood screws will be required to be drilled
directly into underside of desk top.
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs

Page 2 of 5
Slide the large foot and T tube connector into the collar, place the 150°
gasket on top, and fully tighten the 2 M8x16mm bolts into the collar.
(Repeat with all 150° collars).
Using 2 T tubes, connect the assembled corner feet to the bottom T
connector, and fully tighten the 4 M8x16mm bolts.
(Repeat with all 150° feet).
Screw all glides into the base of the large feet, leaving the glides one
turn from tight (then they can be adjusted easily if the floor is uneven).
Place the steel strap onto the upper wrists, with the raised areas of the
straps slotting into the holes on the upper wrist, Fig A. Fully tighten the
M8x25mm bolts. (Repeat with all upper wrists and steel straps)
01 02
03 04
Fig A
ASSEMBLY INSTRUCTIONS
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs

Place a feet tube on top of each collar, and the upper wrist assembly on top
of the feet tubes. Fully tighten the M10x30mm bolts through the upper wrists,
and M10x110mm bolt, spring washer and flat washer through the collars.
Place the assembled leg sets together using the bottom rail, and fully
tighten the M8x16mm bolts to lock all legs together.
Slide each top rail through the upper wrists, making sure
they are located in the centre of the frame.
Place the top rail caps into the exposed holes on each end
of the frame assembly.
Page 3 of 5
05 06
07 08
ASSEMBLY INSTRUCTIONS
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs

Tighten all small grub screws located on the bottom of
each upper wrist.
Snap the plastic support brackets onto the centre of
each top rail. The frame assembly is now complete.
Optional: For extra strength, the plastic support brackets
can be screwed onto the top rails.
Fully tighten all M5x30mm screws through each upper wrist into the
work surface. Fully tighten all M5x20mm screws through each steel
strap and plastic support into the work surface.
Page 4 of 5
ASSEMBLY INSTRUCTIONS
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs
09 10
11 12

Attach cable baskets to the underside of work
surface using the instructions supplied.
Page 5 of 5
ASSEMBLY INSTRUCTIONS
Need help!
Call us on
1300 527 665
www.jasonl.com.au
Blackjack Premium
Rectangle Boardroom Table
Indented Chrome Legs
13