Javad TRIUMPH-1M User manual

All contents in this manual are copyrighted by JAVAD GNSS.
All rights reserved. The information contained herein may not be used, accessed, copied,
stored, displayed, sold, modified, published, or distributed, or otherwise reproduced without express
written consent from JAVAD GNSS.
How to configure
TRIUMPH-1M as a
Base/Rover
with Repeater using
JMobile
Version 1.0
Last Revised March 2, 2019

TRIUMPH-1M as a Base HPT435BT as repeater TRIUMPH-1M as a Rover
To configure HPT435BT as a repeater, the soware JAVAD HPT Repeater Setup (available from Google Play) for
Android devices could be used.

www.javad.com
3
How to configure TRIUMPH-1M as a Base Station
with Repeater
1. To connect the Base to JMobile, use Bluetooth.
For this run the JMobile soware, and tap “Connect”.
Choose the receiver from list.
2. Open the RTK Base item from Main menu.
3. Setup the Base position. Find the three types of posi-
tioning:
• Get From Receiver;
• Get From Catalog;
• Set Coordinates.
4. Scroll little down to configure the UHF radio. Tap on
the “Radio (Unknown)” and choose “My UHF Radio”.

www.javad.com 4
5. To set up the UHF radio with Repeater:
• Check all settings;
• Activate Repeater Mode (Use Repeater).
1.6 Start Base Station: tap “Start” or “Restart station” if
it was started early.
How to Configure TRIUMPH-1M as a Rover with
Repeater
1. Connect to Rover by Bluetooth
2. Open the RTK Rover item from Main menu.

www.javad.com
5
3. Tap “Correction Source (Unknown)” and choose “My
UHF Radio”.
4. Check current UHF Settings and change it (press to
UHF settings)
5. Apply Settings:
• Check Current UHF settings
• Activate Repeater
• Apply Changes
6. Start Rover: tap “Start”.

www.javad.com 6

900 Rock Avenue, San Jose,
CA 95131, USA
Phone: [phone]
Fax : [phone]
www.javad.com
All rights reserved © JAVAD GNSS, Inc., 2019