DUPLICATION SEQUENCE
Press buttons 1 and 2 at the same
time until the red LED starts to
flash. Release and wait until it
turns off.
Press buttons 1 and 3 at the same
time until the red LED starts to
flash.
Release and wait until it turns off.
1 2
3
4
12
3
4
1 2
3
4
1 2
3
4
1 2
3
4
1 2
3
4
Press the button you wish to save
to. The LED will turn red.
12
3
4
1 2
3
4
Press the desired button on the
original remote control and hold
until the LED on the M-SP2 remote
control turns green.
1 2
3
4
If the green LED switches
off after a while,
the copy has been
successful.
1 2
3
4
1 2
3
4
If the LED switches to
red, it is a rolling code
remote control and
needs a second data set
transfer.
If the LED switches to
red, it is a rolling code
remote control and
needs three data set
transfers.
1 2
3
4
1 2
3
4
1 2
3
4
1 2
3
4
If the LED starts flashing
green, the code has been
captured but not verified.
We recommend starting
the process again.
1 2
3
4
1 2
3
4
1 2
3
4
1 2
3
4
1 2
3
4
If the LED starts flashing
red, the code has not been
captured correctly. Try
again but move the original
remote control closer or
further away.
1 2
3
4
1 2
3
4
Press the desired button
on the original remote
control and hold until the
LED on the M-SP2 remote
control turns green.
Press the desired
button on the original
remote control and
hold until the LED on
the M-SP2 remote
control turns green.
If the LED starts
flashing red,
the rolling code
cannot be duplicated.
Wait until the green
LED flashes.
1 2
3
4
1 2
3
4
Button 1: Automatic mode
Button 2: Manualmode
Follow the instructions in the manual on how to enter a specific code.
Button 3: Clonemode
Button 4: Scanner mode
Follow the instructions in the manual on what to do with the receiver.
B. Known fixed code
A. Rolling/fixed or unknown code
1 2
3
4
1 2
3
4
Press the button
corresponding to the
desired duplication
mode. The LED will
switch off and the
remote control will be
programmed.
remotes.jma.es/en
