John Lewis House User manual

Please retain these instructions for future reference.
John Lewis Partnership
171Victoria Street
London SW1E 5NN
johnlewis.com
Made in China
Care instructions
Check that all assembly ttings are tight on a regular basis.
Practical advice
Clean with a mild soapy solution and wipe o with a dry cloth.
Cleaning products may contain chemicals which can have a corrosive eect.
Warnings!
This product should betted in accordance with the manufacturer’s tting instructions
- see diagram overleaf.
This tting pack contains small items which should be kept away from small children.
Do not place very hot or very cold items onto the glass surface unless adequate insulation
material is used.
Safety
Wear suitable eye protection when drilling.When using power tools near water - for added
protection against electric shock the use of a residual current device is advised.
Beware of hidden pipes or power cables.Take care when drilling on glazed tile surfaces in case
the drill slips.
User manual
House
by John Lewis
Mirror
BathshopAccessory

Thank you for purchasing this product.Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product. It is recommended that this product
should only be installed by persons competent in DIY. Before beginning assembly,please
ensure you have all parts outlined in the parts list below.
Assembly
You will need a power drill, 6mm masonry drill bit,medium cross-head screwdriver, tape
measure,spirit level and a pencil to install this product.
Ensure the wall surface is of suitable strength and construction.
Note:The wall plugs provided are suitable for solid stone or brick walls.For other wall types
(e.g hollow plasterboard) use appropriate wall plugs and drill bit.
To adjust angle of mirror, adjust length of screw hooks protruding from wall. Do not expose
threaded part of hook.To hang mirror vertically (ie ush to wall) refer to diagram Abelow.
To hang mirror at an angle refer to diagramBbelow.
If in doubt,consult a qualied person.
Parts list
Mirror
Wall hooks ( ×2)
Wall plugs (×2)
Material composition
Silver mirror
1
2
Ensure holes
are level
Locate mirror
over wall hooks
Mark hole
positions
Locate and mark centres using
mirror assembly as template
Wall plugs
Wall hooks
6mm drill
!
3
4
56
Spacer buttons
A B
To adjust angle of mirror
Do not expose
threaded
part of hook X
HS10_RTL_280818