John Lewis 803/40901 User manual

John Lewis
Fran Botanist 90cm Children’s Bed
Single Stock number: 803/40901
Thank you for purchasing this Fran Botanist Bedstead. Please read the instructions carefully before
use to ensure safe and satisfactory operation of this product.
For product support or spare parts please
call the John Lewis Helpline;
T: 01244 689949
E: [email protected]
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline.
This product takes approximately 40 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL PARTS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: [email protected]
This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
1/5

Fittings and parts checklist
Parts
Fittings
2/5

Step by step assembly instructions
Step One
Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Plastic Spacer (G) and
Screw M6x25mm (A). Tighten using Allen Key (E).
Step Two
Place the Tubing Slats (4) into the slots on the Side Rails (3) using Screw M6x38mm (B) and
Screw Nut (C). Tighten using Allen Key (E) and Wrench (F).
3/5

Step Three
Ensuring that the Wooden Slats (5) are facing curved side up, place a Cap End (D) onto each end of
the Wooden Slats (5) as shown in Fig.1. Now, attach each Cap End (D) onto the Side Rails (3) as
detailed Fig.2.
Step Four
This bed is now ready to use.
4/5

Care and Maintenance
Safety Instructions
Metal Furniture
A slightly damp cloth is the best cleaning agent for your Fran Botanist bedstead.
Do not use any abrasive cleaner or harsh detergent as this can damage the surface.
General warnings:
Never drag furniture when moving it. Always lift it.
Periodically check all fixings to ensure none have come loose and re-tighten where necessary.
Please take care when handling or moving the furniture as careless handling may cause damage
or injury.
Furniture can be dangerous if incorrectly installed. Assembly should be carried out by a competent
adult.
No liability will be accepted for damage or injury caused by incorrectly installed or assembled furniture.
During assembly children should be kept away from the product due to possible risk of injury.
Do not use this item if any components are missing or damaged.
Warning: Not suitable for children under 4 years old.
Warning: Do not place this child’s bed near heat sources, windows and other furniture.
Warning: Do not use this child’s bed if any part is broken, torn or missing.
Children are likely to play, bounce, jump and climb on beds, therefore the child’s bed should not be
placed too close to other furniture or windows, blind cords, curtain pulls or other strings or cords and
should be placed either tight to any wall or have a gap of 300mm between the wall and the side of the
bed.
This product complies with BS 8509:2008 + A1:2011.
If you require any additional information or have any issues with this product please call the
John Lewis Helpline on 01244 689949 or email [email protected].
This bed is for use with a standard single size mattress L190 x W90 x H18.
John Lewis Partnership 171 Victoria Street London SW1E 5NN
www.johnlewis.com
5/5