John Lewis Resto Bedstead User manual

John Lewis
King
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline.
This product takes approximately 40 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL PARTS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: [e-mail]
For product support or spare parts
please call the John Lewis Helpline;
Tel:01244 - 689949
e-mail:[email protected]
Stock number black: 803/44911
Stock number cream: 803/45031
Resto Bedstead
Thank you for purchasing this Resto Bedstead. Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.

Fitting and parts checklist
Wooden Slats x 28
M6 x 30mm Bolt
x 4
M6 Nut x 6
Centre Plastic Holder
x 14
M6 Lock Nut x 4
M6 x 25mm Bolt
x 8
M6 x 35mm Bolt
x 6
x 2

Step by step assembly instructions
Step One
1
2
3Repeat this for all 4 corners.
Attach the Side Rails (3) to the Headboard (1) and Footboard (2) using Washer (A) and
M6 x 25mm Bolt (B). Tighten using Allen Key (J) as shown in the diagram below.
Step Two
5
5
C
E
C
E
C
E
Place the Cross Bars (5) onto the Side Rails (3) and secure using M6 x 30mm Bolt (C) and
M6 Nut (E). Tighten using Allen Key (J) as shown below.
C
E
J
J
Repeat this for all 4 corners.

Step Three
5
D5
7
6
F
Ensuring the holes along the Centre Rail (7) are facing upwards, attach to the underside of the Cross Bars (5)
using M6 x 35mm Bolt (D). Screw the Adjuster (F) fully into the bottom of the Supporting Legs (6). Attach the
Supporting Legs (6) into the pre - drilled holes on the underside of the Centre Rail (7) using M6 x 35mm Bolt (D)
and M6 Lock Nut (I) as shown in the below diagram.
Note: Once the Supporting Legs (6) are secured in place, unscrew the Adjuster (F) slightly,
ensuring there is a 5mm gap between the Adjuster (F) and hard point of the floor.
7
Starting at the Headboard (1), attach the Centre Plastic Holders (G) into the holes along the Centre Rail (7).
Ensuring the Wooden Slats (4) are facing curved side up, place a Side Plastic Holder (H) onto the end of the
Wooden Slats (4). Insert the other slat end into the Centre Plastic Holder (G) then push the end with the Side
Plastic Holder (H) into the pre-drilled holes along the Side Rails (3). Repeat this process for all the Wooden Slats (4).
Step Four

This product complies with BS 1725:1998
e