John Lewis Silentnight Oscar Bunk Bed 803/63201 Quick start guide

John Lewis
Oscar 90cm Bunk Bed
Stock number: 803/63201
Thank you for purchasing this Oscar . Please read the instructions carefully before use to
ensure safe and satisfactory operation of this product.
Pre-assembly Preparation
Please ensure instructions are read in full before attempting to assemble this product.
Necessary Tools
Please check the pack contents before attempting to assemble this product. A full checklist of
components is given in this leaflet. If any components are missing, please contact the John Lewis Helpline.
This product takes approximately 1 HOUR to assemble with 2 PEOPLE.
The fittings pack contains SMALL PARTS which should be KEPT AWAY FROM YOUNG
CHILDREN.
Read this leaflet in full before commencing assembly.
If you require any additional information or have any issues with this product please call the John Lewis
Helpline on 01244 - 689949 or e-mail: [email protected]
This product is HEAVY. It should be assembled as near as possible to the point of use. TAKE CARE
WHEN LIFTING to avoid personal injury and (or) damage to the product.
1/5
For product support or spare parts
please call the John Lewis Helpline;
Tel: 01244 - 689949
e-mail:[email protected]
Bunk Bed

Fittings and parts checklist
Fittings
A B
C D
E F
2/5
JCBC Screw x 8
(M8x 75 mm)
JCBC Screw x 6
JCBC Screw x 4
(M6 x 65 mm)
JCBC Screw x 3
G H
(M6 x 55 mm) (M6 x 15 mm)
Rect. Connector x 8
( 25 x 50 mm)
Washer x 6
(19 mm)
M4 Allen Key x 1M5 Allen Key x 1
Bedstead Parts
Headboard x 11 2
3 4
5
Footboard x 1
Upper Base x 1
Front Guardrail x 1 6 Back Guardrail x 1
Under Base x 1
7 Ladder x 1
Please Note Position of Holes When Identifying Parts
*Please Note:
Footboard
does not have
hole in top - left
corner

Step by step assembly instructions
Step One
Attach the Under Base (4) to the Headboard (1) and Footboard (2) using Rect. Connector (E) and
JCBC Screw M8 x 75 mm (A) and hand-tighten to loosely secure parts together. Do not tighten
with Allen Key (H) until you have put all parts together.
A
H
E
A
A
A
A
E
E
4
3
E
A
A
A
E
A
E
2
1
Step Two
Attach the Back Guardrail (6) to the Upper Base (3) using JCBC Screw M6 x 15 mm (D), then to the
Headboard (1) and Footboard (2) using Washer (F) on the inside of the headboard (as shown) and
JCBC Screw M6 x 55 mm (C). Again, hand-tighten parts together. Repeat for the Front Guardrail (5).
3/5
C
C
1
6
C
C
2
C
C
D
D
5
D
D
C
C
F
F
LOOSELY SECURE PARTS
TOGETHER IN EACH STEP
SO ALL PARTS FIT
TOGETHER SMOOTHLY UNTIL
TIGHTENING AT THE END
PLEASE NOTE THE
WASHERS (F) SHOULD
BE PLACED ON THE
INSIDE OF THE
HEADBOARD (1) AS
SHOWN ABOVE

Step Three
Attach the Ladder (7) to the Upper Base (3) and the Under Base (4) using JCBC Screw
M6 x 65 mm (B). Now, tighten all parts together using the appropriate Allen Key - (G) and (H).
BB
B
B
7
Step Four
This bed is now ready to use.
4/5

Care and Maintenance
Safety Instructions
Metal Furniture
A slightly damp cloth is the best cleaning agent for your Oscar bedstead.
Do not use any abrasive cleaner or harsh detergent as this can damage the surface.
General warnings:
All assembly fastenings should always be tightened properly and care should be taken that no
fittings are loose.
The maximum thickness of the mattresses should not be more than 18cm and the upper surface of
the mattress should not be more than the mattress maximum thickness marking.
The bunk bed should not be used if any structural part is broken or missing.
Children can strangle in items such as ropes, strings, cords, harnesses and belts attached to or
hung on a bunk bed.
Warning: Children can become trapped between the bed and the wall. To avoid risk of serious
injury the distance between the top safety barrier and the wall shall not exceed 75 mm nor shall
be more than 230 mm.
Warning: High beds and the upper bed of the bunk beds are not suitable for children under six
years due to the risk of injury from falls.
This product complies to BS EN 747-1+2:2012+A1:2015.
If you require any additional information or have any issues with this product please call the
John Lewis Helpline on 01244 689949 or email [email protected]
This bed is for use with a standard single size mattress L190 x W90 x H18.
John Lewis Partnership 171 Victoria Street London SW1E 5NN
www.johnlewis.com
5/5