John Thomas HAMPTON OT-70SC User manual

ITEM
NO.
:
OT
-
70SC
REVISED APR 06, 2013
Printed in Vietnam
- 1 -
Description
Item No.
: HAMPTON SQUARE COFFEE TABLE
: OT-70SC
ASSEMBLY INSTRUCTIONS

ITEM
NO.
:
OT
-
70SC
REVISED APR 06, 2013
Printed in Vietnam
- 2 -
BEFORE ASSEMB
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
PART
LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1 B Bottom Shelf 1
C Side
Frame 2
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM
NO.
:
OT
-
70SC
REVISED APR 06, 2013
Printed in Vietnam
- 3 -
HARDWARE LIST
When unpacking, please carefully not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO Description Qty Sketch NO Description Qty Sketch
1 Bolt
(M6x35mm) 12 2 Flat washer (6.5x13mm) 12
3 Lock washer
(6.5x11mm) 12 4 Allen Key
(4 x 80mm) 1
STEP 1
Attach side frame (C) to the top (A) with bolt (1), washer (2) and (3) as shown below. Tighten with
allen key (4).

ITEM
NO.
:
OT
-
70SC
REVISED APR 06, 2013
Printed in Vietnam
- 4 -
STEP
2
Attach Bottom shelf (B) to side frames (C) with bolts (1), washers (2) and (3) as shown below. Tighten
with Allen key (4).