John Thomas T-36RXT User manual

ITEM NO.: T
-
36RXT
AND
T-30P(PACKED IN SEPARATE BOX)
REVISED AUG
20
, 2014
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No. : 36X36X48 DINING TOP
: T-36RXT AND T-30P (PACKED IN SEPARATE BOX)

ITEM NO.: T
-
36RXT
AND
T-30P(PACKED IN SEPARATE BOX)
REVISED AUG
20
, 2014
Printed in Vietnam
- 2 -
BEFORE ASSEMB
LY
Thank you for purchasing this quality product. This product has been designed for easy assembly and
constructed for durability. All parts were checked prior to packaging to insure quality. Prior to beginning
assembly, however, make sure all parts and hardware are included and free of obvious defect. If a part is
missing or defective, please contact the store where purchased. If hardware is missing, or you need help with
assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the parts from
being scratched.
-Remove all wrapping material, including staples & packing straps before you start to assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the finish of your
table. Protect the surface of the table with cloth if you are using any product with rubber feet or base.
PART
LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO Description Qty Sketch NO Description Qty Sketch
A Top 1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qt
y
Sketch
NO
Description
Q
ty
Sketch
1 Bolt
( M6x35mm) 4
2 Lock washer
(6.5x11mm) 4
3 Flat washer
( 6.5x13mm) 4
4 Allen Key
(4x80mm) 1

ITEM NO.: T
-
36RXT
AND
T-30P(PACKED IN SEPARATE BOX)
REVISED AUG
20
, 2014
Printed in Vietnam
- 3 -
STEP 1
Unlock the table top on both sides from underneath the top. Pull the 2 parts of the table top apart
and remove the leaf as shown below.
STEP 2
Attach Top (A) to the Base (B) by using bolts (1), and washers (2) and (3) as shown below. Tighten
with Allen key (4).

ITEM NO.: T
-
36RXT
AND
T-30P(PACKED IN SEPARATE BOX)
REVISED AUG
20
, 2014
Printed in Vietnam
- 4 -
STEP 3
Unlock the table top from both sides underneath of the top as shown below.
Pull the 2 parts of the table top apart.
STEP 4
Place the leaf in the center of the open table top. Push the table top closed. Lock the mechanism
underneath 2 sides of the table top as shown below.