John Thomas ROMA C-310 User manual

ITEM NO. : C-310
REVISED APR 29, 2016
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: ROMA LADDERBACK CHAIR RTA
: C-310

ITEM NO. : C-310
REVISED APR 29, 2016
Printed in Vietnam
- 2 -
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws, bolts until completely assembled.
-Keep all hardware parts out of reach of children.
BEFORE ASSEMBLY
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO. : C-310
REVISED APR 29, 2016
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Back
1
B
Seat Frame
1
C
Seat
1
D
Front Leg
(L-R)
2
E
Side
Stretcher
(L-R)
2
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Short bolt
( M6 x 40mm)
3
2
Medium bolt
(M6 x 60mm)
4
3
Long bolt
(M6 x 80mm)
4
4
Wood Screw
(M4 x 35mm)
8
5
Lock Washer
(6.5 x11mm)
11
6
Flat Washer
(6.5 x19mm)
11
7
Allen Key
(M4 x 30mm x 120mm)
1

ITEM NO. : C-310
REVISED APR 29, 2016
Printed in Vietnam
- 4 -
STEP 1
Attach the seat frame (B) to the back (A) with bolts (1) and (3), and washers (5) and (6) as shown
below. Tighten with Allen key (7).
Note: DO NOT tighten any of the bolts, until the chair is assembled, then put on a flat level surface to
make sure the chair is level and then tighten the bolts.
STEP 2
Attach front legs (D) to the seat frame (B) with bolts (2), and washers (5) and (6) as shown below.
Tighten with Allen key (7).
Attach side stretchers (E) to front legs (D) and legs of the back (A) with screws (4) as shown below.
Tighten with a screwdriver.

ITEM NO. : C-310
REVISED APR 29, 2016
Printed in Vietnam
- 5 -
STEP 3
Attach the seat (C) to top of the seat frame (B) with screws (4) as shown below. Tighten with a
screwdriver.