FX22/FX62 Supervisory Controllers Installation Instructions 3
Safety Precautions
NiMH Battery Precautions
Static Discharge Precautions
Static charges produce voltages high enough to
damage electronic components. The microprocessors
and associated circuitry within the FX22/FX62 is
sensitive to static discharge.
Accessories
Standard accessories for the FX22/FX62 are listed in
Table 1. See About Option Cards on page 10 for
information on custom option cards.
Mounting
Perform these actions before mounting the FX22/FX62
Supervisory Controller:
• Remove any wiring knockouts needed. See Locate
and Remove the Chassis Knockouts on page 6.
• Install the SIM card for the integral GPRS modem
(if applicable). See Insert the SIM Card and Attach
the GPRS Antenna on page 7.
• Install any option card (if applicable). See About
Option Cards on page 10.
Mount the FX22/FX62 Supervisory Controller in a
location that allows clearance for wiring, servicing, and
removal of covers.
CAUTION: Risk of Electric Shock.
Disconnect the power supply before
making electrical connections to avoid
electric shock.
Mise En Garde: Risque de décharge
électrique. Débrancher l'alimentation
avant de réaliser tout raccordement
électrique afin d'éviter tout risque de
décharge électrique.
IMPORTANT: Use copper conductors only. Make
all wiring in accordance with local, national, and
regional regulations. Do not exceed the FX22/FX62
Supervisory Controller’s electrical ratings.
IMPORTANT: To reduce the risk of fire or electrical
shock, install in a controlled environment relatively
free of contaminants.
IMPORTANT: Use this FX22/FX62 Supervisory
Controller only as an operating control. Where
failure or malfunction of the FX22/FX62 could lead
to personal injury or property damage to the
controlled equipment or other property, additional
precautions must be designed into the control
system. Incorporate and maintain other devices,
such as supervisory or alarm systems or safety or
limit controls, intended to warn of or protect against
failure or malfunction of the FX22/FX62.
IMPORTANT: Overcharging, short circuiting,
reverse charging, mutilation, or incineration of the
cells and the batteries must be avoided to prevent
one or more of the following occurrences: Release
of toxic materials, release of hydrogen and/or
oxygen gas, rise in surface temperature.
IMPORTANT: If a cell or battery has leaked or
vented, replace it immediately using protective
gloves.
IMPORTANT: If and when necessary, these cells or
batteries must be replaced with identical new ones
from the same manufacturer. If a cell or a battery to
be replaced is connected with other cells or batteries
in series, it is recommended that the other cells or
batteries be replaced with new ones at the same
time.
IMPORTANT: Reverse polarity installation of the
cell or the battery in the end product must be
avoided.
IMPORTANT: Work in a static free area. Discharge
any static electricity you may have accumulated.
Discharge static electricity by touching a known,
securely grounded object. Do not handle the Printed
Circuit Board (PCB) without proper protection
against static discharge. Use a wrist strap when
handling PCBs. Secure the wrist strap clamp to
earth ground.
Table 1: Standard Accessories for FX22/FX62
Supervisory Controllers
Part Number Description
LP-FXGPRSE-0 6.56 ft (2 m) SMA-type coax
extension cable, with mounting
bracket. See Figure 8 and Figure 9.
LP-KITFX2DB-0 Adapter, RJ-45 to DB-9 null modem,
for onboard RS-232 serial port to
connect to DTE device.
