Jumpking JK13S017 User manual

Model# JK13S017
The trampoline/ enclosure is designed for users weighing 90kg (200 lbs.) or less.
Ladder is not supplied with trampoline.
This enclosure is to be used only in connection with certain trampolines.
Use the trampoline and trampoline enclosure only with mature knowledgeable
supervision.

(see illustration)

straight enclosure pole(12)
Lay a straight enclosure pole(12) and a curved
enclosure pole(13) with plastic cap on the ground.
Make sure that the straight enclosure pole(12) is
oriented so the small holes are in position shown.
Slide a foam sleeve(16) onto each of the tubes;
note that the ends of the straight enclosure
pole(12) should not be covered.
Insert the straight enclosure pole(12) into the
curved enclosure pole(13). Tighten a self-tapping
screw(11) into the small hole in the poles(12 &
13).
Assemble the remaining straight enclosure
pole(12), curved enclosure pole(13), and foam
sleeve(16) in the same way.
Insert the end of straight enclosure pole(12 & 13)
into the hole of T-connector+welded tube(4).
Attach the other three straight enclosure poles(12
& 13) in the same way. See inset drawing.

9b
19
15
15
15
15
15
15
19
19
19
19
19
19
See inset drawing for attached of rod:
Plastic cap(14) has been attached to the top of the
curved enclosure pole(13).
Attach the first hanging point at the upper edge of the
netting(15) with the rod to the plastic cap(14) of
curved enclosure pole(13). Attach a second hanging
point directly across the netting(15) from the first
hanging point.
curved
enclosure
pole(13)

200

19
19
2
Straight enclosure pole
Curved enclosure pole