90 avantgarde).
Please note that not all available accounting
systems are compatible with the payment box. The
payment box has been tested with the following
accounting systems:
ZNRI G-13 Coin Validator
ZHug-Witschi DIVA2
ZPBV Kaufmann Mifare-Vending-Reader VR1
ZMicrotronic Mlight5-Leser
ZFage Oscar/Giody
ZEvis Legic Gecko
EYou can always find the most up-to-date list
on our website (www.jura.com).
Maintenance
Do not use harsh or abrasive cleaning agents or
hard objects to clean the machine. These may
damage the coating of the housing.
2 Installing the payment box
ETo connect the payment box to the coffee
machine, a functioning accounting system
must be installed.
EThe steps for installation in the coffee
machine depend on whether you are using
the Intelligent Fresh Water Kit or not.
ERemove the rear wall of the payment box to
connect the various cables to the MDB
interface. Screws for attaching the rear wall
from the inside after connecting the cables
are supplied with the unit.
Connecting to the machine without the
Intelligent Fresh Water Kit
TSwitch off the coffee machine at the power
switch.
TMove switch for accounting mode to
bottom position (payment mode).
TConnect RS232 cable to coffee machine.
TInsert the mains plug into a power socket.
TSwitch on coffee machine.
The payment box and automatic coffee
machine are ready for use.
Connecting to the machine with the Intelli-
gent Fresh Water Kit
TSwitch off the coffee machine at the power
switch.
TMove switch for accounting mode to
bottom position (payment mode).
TConnect RS232 cable to Mini Hub of Intelli-
gent Fresh Water Kit.
TInsert the mains plug into a power socket.
TSwitch on coffee machine.
The payment box and automatic coffee
machine are ready for use.
3 Configuring the payment box
Follow the steps below to configure the payment
box (e.g. select the machine type).
Precondition: the PC software of the payment
box is installed.
TSwitch off the coffee machine at the power
switch.
TUnplug the payment box from the power
socket.
TRemove the RS232 cable.
TConnect the payment box to the PC with the
USB cable.
TInsert the mains plug of the payment box
into a power socket.
The payment box will switch on.
TConfigure the payment box with the PC
software.
EThe instructions for use for the PC software
are contained in the software.