Jura S8 User manual

S8 – Quick Reference Guide
All manuals and user guides at all-guides.com
all-guides.com

2
S8 – Quick Reference Guide
S8 – Quick Reference Guide
J
These short instructions do not replace the ‘S8 Instructions for Use’.
Make sure you read and observe the safety information and war-
nings first in order to avoid hazards.
You can initiate the rinse operation manually at any time.
Precondition: The start screen is displayed.
TPlace one receptacle under the coffee spout and another
under the fine foam frother.
TTouch ‘ P ’.
‘Machine settings’
TMove your finger across the display until ‘Maintenance sta-
tus’ is displayed in the centre.
TTouch ‘Maintenance status’.
‘Clean’
TMove your finger across the display until ‘Rinse’ is displayed
in the centre.
TTouch ‘Rinse’ to start the rinse operation.
‘Machine is rinsing’
‘Milk system is being rinsed’
The rinse stops automatically. The start screen is displayed.
15 minutes after milk preparation, the milk system is automatically
rinsed. Therefore always place a receptacle under the milk system
after preparing milk.
Rinsing the machine
Automatic milk system
rinsing
All manuals and user guides at all-guides.com

3
S8 – Quick Reference Guide
To ensure that the milk system always works properly, you must
clean it daily when you have been preparing milk.
If the wrong cleaning agent is used, the machine could be damaged
and/or traces could be left behind in the water.
TUse only original JURA maintenance products.
EJURA milk system cleaner is available from specialised dealers.
ETo clean the milk system, use the container supplied.
Precondition: The start screen is displayed. ‘Clean the milk system’
is displayed.
TTouch ‘Clean the milk system’.
TTouch ‘Clean the milk system’ again.
TTouch ‘Start’.
TTouch ‘Start’ again.
‘Milk system cleaner’ / ‘Connect the milk tube’ / ‘Fresh water’
TRemove the milk pipe from the milk container or milk cooler.
TAdd milk system cleaner to the front part of the container
up to the bottom mark (indicated by 6).
TThen fill with water up to the upper mark.
TPlace the container under the fine foam frother.
TConnect the milk pipe to the container.
ETo connect the milk pipe to the container correctly, the pipe
must be fitted with a connector.
TTouch ‘Next’.
‘Milk system is being cleaned’
The operation is interrupted, ‘Fresh water’.
TRinse the container thoroughly and fill the front part with
fresh water up to the upper mark.
TPlace this under the fine foam frother and reconnect the
milk pipe to the container.
TTouch ‘Next’.
‘Milk system is being cleaned’
The operation stops automatically.
Cleaning the milk system
CAUTION
6
All manuals and user guides at all-guides.com

4
S8 – Quick Reference Guide
To make sure the professional fine foam frother works properly, and
in the interests of hygiene, it must be dismantled and rinsed daily if
you have been preparing milk.
TRemove the milk pipe and rinse it thoroughly under running
water.
TRemove the professional fine foam frother.
TDismantle the fine foam frother into its individual parts.
TRinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 250 ml cold water and 1 capful of JURA milk
system cleaner. Then rinse the parts thoroughly.
TRe-assemble the professional fine foam frother.
EEnsure that all individual parts are correctly and firmly con-
nected to ensure optimum operation of the professional fine
foam frother.
TRe-fit the fine foam frother on the milk system.
Dismantling and rinsing
the professional fine
foam frother
1
2
All manuals and user guides at all-guides.com

5
S8 – Quick Reference Guide
Your S8 no longer has to be descaled if you are using the CLARIS
Smart filter cartridge.
Precondition: The start screen is displayed.
TRemove and empty the water tank.
TFit the filter cartridge extension supplied on top of a CLARIS
Smart filter cartridge.
TInsert the filter cartridge with its extension into the water
tank.
TTurn the filter cartridge clockwise until it audibly clicks into
place.
TFill the water tank with fresh, cold water and reinsert the
tank.
EThe machine automatically detects that you have just inserted
the filter cartridge.
‘Saved’ appears briefly on the display.
‘Filter is being rinsed’, water flows directly into the drip tray.
Rinsing of the filter stops automatically.
‘Empty drip tray’
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
The start screen is displayed.
EIf the filter is active, this is indicated by a blue filter symbol at
the top of the display.
EOnce the filter cartridge stops working (depending on the
water hardness setting), the S8 will prompt you to change the
filter.
ECLARIS Smart filter cartridges are available from specialised
dealers.
Precondition: The start screen is displayed. ‘Change the filter’ is dis-
played.
TTouch ‘Change the filter’.
TTouch ‘Change the filter’ again.
‘Change filter’
TRemove and empty the water tank.
Inserting the filter
Changing the filter
All manuals and user guides at all-guides.com

6
S8 – Quick Reference Guide
TTurn the filter cartridge anticlockwise and remove it along
with the extension from the water tank.
TFit the filter cartridge extension on top of a new CLARIS
Smart filter cartridge.
TInsert the filter cartridge with its extension into the water
tank.
TTurn the filter cartridge clockwise until it audibly clicks into
place.
TFill the water tank with fresh, cold water and reinsert the
tank.
‘Saved’ appears briefly on the display. The machine has
automatically detected that you have just changed the filter
cartridge.
‘Filter is being rinsed’, water flows directly into the drip tray.
Rinsing of the filter stops automatically.
‘Empty drip tray’
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
The start screen is displayed.
EIf the filter is active, this is indicated by a blue filter symbol at
the top of the display.
After 180 preparations or 80 switch-on rinses, the S8 will prompt you
to clean it.
If the wrong cleaning agent is used, the machine could be damaged
and/or traces could be left behind in the water.
TUse only original JURA maintenance products.
EThe cleaning programme lasts approximately 20 minutes.
EDo not interrupt the cleaning programme. The quality of
cleaning will be impaired if you do so.
EJURA cleaning tablets are available from specialised dealers.
Precondition: The start screen is displayed. ‘Clean machine’ is dis-
played.
TTouch ‘Clean machine’.
‘Clean’
TTouch ‘Clean’.
Cleaning the machine
CAUTION
All manuals and user guides at all-guides.com
all-guides.com

7
S8 – Quick Reference Guide
TTouch ‘Start’.
TTouch ‘Start’ again.
‘Empty coffee grounds container’
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
TPlace one receptacle under the coffee spout and another
under the fine foam frother.
TTouch ‘Next’.
‘Machine is being cleaned’ appears and water flows out of
the coffee spout and the fine foam frother.
The operation is interrupted, ‘Add cleaning tablet’.
TOpen the cover of the filler funnel for ground coffee.
TInsert a JURA cleaning tablet into the filler funnel.
TClose the cover of the filler funnel.
TTouch ‘Next’.
‘Machine is being cleaned’, water flows repeatedly out of the
coffee spout and the fine foam frother.
The operation stops automatically.
‘Empty coffee grounds container’
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
Cleaning is now complete. The start screen is displayed.
The S8 builds up deposits of limescale over time and automatically
prompts you to descale it when necessary. The degree of calcifica-
tion depends on the hardness of your water.
EIf you are using a CLARIS Smart filter cartridge, you will not be
prompted to descale.
If the descaling agent comes into contact with the skin or eyes, this
can cause irritation.
TAvoid contact with the skin or eyes.
TRinse off the descaling agent with clean water. Should you get
any descaling agent in your eye, see a doctor.
If the wrong descaling agent is used, the machine could be dama-
ged and/or traces could be left behind in the water.
TUse only original JURA maintenance products.
Descaling the machine
JCAUTION
CAUTION
All manuals and user guides at all-guides.com

8
S8 – Quick Reference Guide
If the descaling operation is interrupted, there may be damage to
the machine.
TAllow the descaling programme to run to the end.
If the descaling agent comes into contact with sensitive surfaces
(e.g. marble), damage cannot be ruled out.
TClean up any splashes immediately.
EThe descaling programme lasts approximately 45 minutes.
EJURA descaling tablets are available from specialised dealers.
Precondition: The start screen is displayed. ‘Decalcify machine’ is
displayed.
TTouch ‘Decalcify machine’.
‘Descale’
TTouch ‘Descale’.
TTouch ‘Start’.
TTouch ‘Start’ again.
‘Empty drip tray’
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
‘Pour descaling agent into water tank’
TRemove and empty the water tank.
TCompletely dissolve 3 JURA descaling tablets in a receptacle
holding 500 ml of water. This may take several minutes.
TPour the solution into the empty water tank and insert it
into the machine.
TPlace one receptacle under the coffee spout and another
under the fine foam frother.
TTouch ‘Next’.
‘Machine is being descaled’ appears and water flows out of
the fine foam frother repeatedly.
The operation is interrupted, ‘Empty drip tray’.
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
‘Fill water tank’
CAUTION
CAUTION
All manuals and user guides at all-guides.com

9
S8 – Quick Reference Guide
TRemove the water tank and rinse it thoroughly.
TFill the water tank with fresh, cold water and reinsert the
tank.
TPlace one receptacle under the coffee spout and another
under the fine foam frother.
TTouch ‘Next’.
‘Machine is being descaled’, the descaling operation is con-
tinued.
The operation is interrupted, ‘Empty drip tray’.
TEmpty the drip tray and coffee grounds container and put
them back into the machine.
Descaling is now complete. The start screen is displayed.
EIf the descaling operation stops unexpectedly, rinse the water
tank thoroughly.
Coffee beans may be covered with a slight oil film which remains on
the walls of the bean container. These traces may negatively affect
the coffee result. For this reason clean the bean container from time
to time.
Precondition: ‘Fill bean container’ is displayed.
TSwitch the machine off with the On/Off button Q.
TRemove the aroma preservation cover.
TClean the bean container with a soft, dry cloth.
TFill the bean container with coffee beans and close the
aroma preservation cover.
Limescale deposits may form in the water tank. To ensure correct
function of the machine, descale the water tank from time to time.
TRemove the water tank.
TIf you use a CLARIS Smart filter cartridge, remove this.
TCompletely fill the water tank and dissolve 3 JURA descaling
tablets in it.
TLeave the water tank with the descaling solution for several
hours (e.g. overnight).
TEmpty the water tank and rinse it thoroughly.
TIf you use a CLARIS Smart filter cartridge, insert this again.
TFill the water tank with fresh, cold water and reinsert the
tank.
Cleaning the bean
container
Descaling the water tank
S8_Kurz/en/201711
All manuals and user guides at all-guides.com