JWA GRANT 716520001 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
GRANT
ITEM CODE 716520001
SOFA TABLE

Allow 15 min For 1 person Additional tool
required
2
PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
2. Take care when lifting. Product should be assembled as near as possible to the
point of use
3. Ensure that you have all required contents for complete assembly
4. Always read the assembly instructions carefully before beginning assembly.
5. Keep all hardware parts and packaging out of reach of small children.
6. Do not over tighten the screws and bolts as this may damage the threads
7. Assembly is to be carried out by a competent adult(s) ONLY
8. During assembly, children should be kept away from the product due to possible
risk to injury.
9. Do not use this item if any components are missing or damaged.
10. Please keep the instructions for future reference.

3
PARTS LIST
1 Top Panel x1
2 Bottom Frame x1
3 Support Leg x4
A M6X10MM BOLT 16 PCS
BHEX KEY 1 PC
FFOOT STICKER 4 PCS

4
STEP 1:
•Prepare a surface with a protective blanket or cardboard.
•Place the top panel(1) flat on the surface.
•Insert the 4xsupport leg(3) onto the top panel(1).
•Secure with bolt(A) per connection. Fasten with allen key(B).
•Fasten only until the bolt is tight in the thread, do not fully fasten
for now.

5
STEP 2:
•Connect bottom frame(2) to support leg(3).
•Secure with bolt(A) per connection. Fasten with allen key(B).
•Attach the 4x footstickers(F) as shown.
•Once levelled turn the table back on its side and fasten all the
bolts.

6
ASSEMBLY IS COMPLETE

7
SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to attach
the Mounting Plate into a stud. If mounting into brick or masonry you will need to
acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and furniture
and that the Wall Strap is snug.

8
PRODUCT CARE:
To protect your furniture, we suggest the following:
•Avoid placing your furniture in direct sunlight.
•Do not place furniture directly under windows.
•Do not place sharp materials (knife, fork, etc.) directly onto your
furniture as sharp material may scrape and damage the finish.
•Do not place material with high temperature directly onto the
surface of your furniture.
•Clean up spills quickly. Water left over a prolonged period of time
may cause damage. Alcohol, perfume, nail polishes, aftershave and
some medication may cause severe finish damage if not cleaned
immediately.
•Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain ingredients
that may react and damage the finish.