JWA PINE CREEK 69490 User manual

1
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
ASSEMBLY INSTRUCTION
PINE CREEK
ITEM CODE 69490
COFFEE TABLE

PRE-ASSEMBLY PREPARATION
Before you start:
1.Choose aclean, level, spacious assembly area.Avoid hard surfaces that may damage the
product
2.Take care when lifting.Product should be assembled as near as possible to the point of
use
3.Ensure that you have all required contents for complete assembly
4.Always read the assembly instructions carefully before beginning assembly.
5.Keep all hardware parts and packaging out of reach of small children.
6.Do not over tighten the screws and bolts as this may damage the threads
2
Allow 45 min For 2person Additional tools required

PARTS LIST
1Top panel
2Bottom panel
E1 Metal frame
E2 Connection pipe
3

Install fitting D to E1, and fix the E2 to E1 with fitting A, the
connection with fitting C and B for installation reinforcement.
STEP 1:
Fix the panel 2 to the E2 with fitting A.
STEP 2:
4

Fix the panel 1 to the E2 with fitting A.
STEP 3:
5
Install fitting H to the side of panel 1 with fitting G, Punch holes
in the wall at the appropriate position and insert the glue I, lock
screw F through H to the wall.
STEP 4:

ASSEMBLY IS COMPLETE
6

SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
7

To protect your furniture, we suggest the following:
• Avoid placing your furniture in direct sunlight.
• Do not place furniture directly under windows.
• Do not place sharp materials (knife, fork, etc.) directly onto
your furniture as sharp material may scrape and damage the
finish.
• Do not place material with high temperature directly onto the
surface of your furniture.
• Clean up spills quickly. Water left over a prolonged period of
time may cause damage. Alcohol, perfume, nail polishes,
aftershave and some medication may cause severe finish
damage if not cleaned immediately.
• Use a clean, soft, dry, lint free absorbent cloth to clean your
furniture. Do not use any detergent as they may contain
ingredients that may react and damage the finish.
NOTE: If the above care advise is not adhered to your product
warranty may become void
8